Feeder fault repair and parts replacement
Electromagnetic vibration feeder electromagnetic vibration by acting, so it all loose joints prone to make Sao jie big sound. If maintenance is not timely, it will cause some damage to parts, the equipment failure rate. In order to maintain feeder job stability and reliability, must be checked regularly. Especially for new use feeder, electromagnetic vibrating feeder and some exciting coils often burned, but can not find a good solution, in fact, the excitation coil assembly adjustment often burned and have a great relationship, are presented assembly adjustment Some methods of electromagnetic vibrating feeder coil.
(1) If the electromagnetic vibrating feeder coil has one or all of Pat
burned, should replace the entire horn unloaded, then split out Pat
burning coil, must not only split armature, springs, and loquat
electromagnet, cast iron housing body attached to the trough, so to the
installer to adjust Fu difficulty.
(2) remove the spring, be sure to press the original program laid out,
because the fixed springs and adjust the spring elastic force, the
height is different, this is the general maintenance workers are
difficult to find, and only on the relatively flat on the ground, from
the height of the can see that difference.
(3) Check the solenoid armature no abnormal phenomenon, put on a new
coil fitted with wood or other insulating strip take along tight,
leveling, and finally with epoxy cement, dried, of course this
operation, in order not to affect equipment operation rate, requiring
the same type of electromagnetic vibrating feeder, at least one magnet
spare, as turnover.
Assembly sequence: put up a cast iron casing mounted electromagnet, a
fastening the last two removed to put a spring loaded armature loss
clearance should comply with the loss put a detached two spring put a
spring cover , screwed to the gap transferred to the specified value
range solid, good coupling portion of the groove. It can then boot, test
its current value.
Comments