Comparison of LED Panel Light Installation Modes

A. Suspension Type
At present, there's no technical difficulty with this installation mode. Firstly, you must fit the suspension components in the back side of the LED panel light, and then attached the lanyard can. As a Customer we advise you not to forget to confirm whether the suspension components are standard accessories from manufacturers or optional parts. We at CNHIDEE give these out as a standard accessory.

B. Embedded Type
Embedded type can be divided as two ways:   
a, Half embedded   
b, Pure insertion
In Borsche, we use pure insertion as below described.
Cutting a hole in the ceiling is a necessary step, at the back of the panel, there is fixing piece called a spring buckle. To install the panel, you will then put the panel sideways into the square hole ensuring that the side buckle springs are secured above the surface of the ceiling cut out and then carefully draw the other two spring buckles to secure the panel to a flat fitting to the ceiling. 
(Feedback from our market, most customers are prefer this mode of installation.)

C. Surface Mounted
Wall mounted is another different installation, this is not hanging and not built-in. The panel must be fixed on a vertical wall or a horizontal ceiling plane by either use of a surface mounting mould or clip on system to an earlier reserved space. It is very necessary to fully match this type of installation to the ceiling, as this will make the room feel and appear full of modern sense. Otherwise it may cause big gap phenomenon in the room design.

Every installation has its own dominance and limits, we at CNHIDEE will recommend the most suitable one for you. For More information please feel free to contact us.