Kodak Printer not printing black with new cartridge
by henry Henry The Global BlogsKnowing how to
troubleshoot common issues on any type of Kodak printer can save you a lot of
money, as the cost of service on a Kodak printer can be quite high. A printer
may occasionally stop Kodak all in one printer black ink not printing? This
does not necessarily imply that your printer is irreparably damaged, but rather
that there is a problem with the black printer cartridge that can be easily
resolved.
·
Lift the lid of your Kodak printer and wait for the print cartridges to
fall into place. Touching the print carriage or attempting to move it by hand
can result in severe damage to the Kodak printer.
·
Tilt the black print cartridge forward and lift the cartridge cover.
Lift the black printer cartridge carefully out of the printer. Close the
printer cover and set aside the print cartridge.
·
Examine the black print cartridge upside down for dried ink and paper
dust. The print cartridge can accumulate debris over time, which can clog the
ink jets and cause the cartridge to stop working.
·
Clean the bottom of the cartridge with a cotton swab dipped in warm
water until all dried ink and paper dust has been removed. If there is a lot of
ink and paper dust, instead of using warm water, use a cotton swab dipped in
isopropyl alcohol.
The following
suggestions will assist you in resolving the Kodak printer not printing in
black ink issue:
Calibration
should be checked:
The problem
with Kodak printers not printing in black ink could be due to incorrect printer
calibration. Even if your Kodak printer was previously calibrated, the
printer's calibration would need to be checked again after inserting a new
cartridge. Users can use the printer's Self Diagnostic feature for this
purpose. To resolve the issue, the printer cartridge alignment feature must
also be used.
Check cartridge
tape:
New black ink
cartridges for your Kodak printer usually come with a protective plastic tape
to prevent ink from spilling. Many users make the mistake of installing the
cartridges without taking off the protective tape. This would cause the
printing problems. Kodak hero printer not printing blacks are advised to
check whether the protective tape is off, and if it is found still with the
cartridge, removing it would solve the issue.
Read this blog if you
want to find out why is my Kodak printer not printing black? Go through
the steps that are given above, as you would be able to find the answer to the
significant questions like, can Kodak printer not printing black with new
cartridge fix?
Some Related Stories To Read:
How to Setup and install Kodak Easyshare Printer on Mac
How do I Setup my Kodak Wireless Printer
Kodak Easy Share Printer Dock Series 3
Sponsor Ads
Created on Jan 27th 2022 03:11. Viewed 203 times.