Epson Printer error code 0xf3

by Stacy Vollmer IT Phone Service

Cause: — There can be many reasons behind the Epson Printer Error Code 0xf3. Some of the reasons behind this error are mentioned below:

  • When bits of paper stuck inside the gears of paper feed.
  • Due to paper jamming.
  • When ink vacuum tubes detached in the printer.
  • There are chances that there is internal conflict is going on inside your Epson Printer.

READ MORE :- epson printer error code 0xf3

Solution: What happens when users see Epson error code 0xf3 displaying on their Epson Printers? Well, this error arises because of the reasons such as — paper jamming, chunks of paper stuck inside the gears of paper feed, ink vacuum tubes get detached, or due to internal conflict.

And, if you are a passionate user of Epson Printers then you can follow the step by step guidance as given below:

  • The first step is to turn off your printer and separate the cartridge from it. Also, remove rear parts (USB, pen drivers, hard disk, etc.).
  • Remove the panel screws from it and set the ink level of your Epson printer.
  • You have to clean the inner region using a soft and dry cotton cloth piece.
  • Now, place all the components back to their place.
  • To check the ink levels follow the steps written below:
  • Turn on your printer. Click the start button to open control panel.
  • Select the option printers and faxes. Then right click on preferences.
  • Select service this device option. You will notice a tool box is open where you can click on the option estimates ink level.
  • You will see the ink levels easily. And you can choose your preferred level as well.

  • You are advised to take down the LCD as the front panel of the device.
  • Now, you have to detach the back panel screws to carefully manage the process.

Source :- epson printer error code 0xf3

Sponsor Ads

About Stacy Vollmer Freshman   IT Phone Service

5 connections, 0 recommendations, 28 honor points.
Joined APSense since, March 8th, 2021, From California, United States.

Created on Mar 24th 2021 07:01. Viewed 236 times.


No comment, be the first to comment.
Please sign in before you comment.