What's the Three Major Use Mistakes of Raymond Mill?

1.Feeding methods

In the crushing process of cone crusher, whether the feeding method is correct or not directly influences the output of equipment. If the feeding method is not correct, may result in the material blockage in equipment operation, in that case, it must stop for repairing, which not only delay the construction but also influence the production efficiency of equipment, so, it's better to keep uniform feeding in the material feeding process, so as to increase the production output and ensure the normal operation.

2.Particle size of the materials

When choosing the materials, the particle size of the materials must be within the prescribed scope of cone crusher's feeding inlet, material size shall not be greater than that range. If the material size is too large and the equipment cannot crush them, firstly you need to break them to the size range acceptable to your own equipment before processing, then using the cone crusher to finish the material fine crushing.

3.Humidity of the materials

If the material moisture content is high, it likely will appear the phenomenon of material adhering to the inside of cone crusher at the time of machine working, thus resulting in the blockage in material transportation, affecting the crushing capacity and production efficiency of cone crusher. So, in the choice of materials, you should choose that can meet your cone crusher's requirements, see if the equipment can crushing materials of high moisture content, if it can, it will not produce low production. If not, you need to deal with the moisture of the material before being crushed.