How To Reset Epson Printer 817 442 6637 Configure Your Epson Printer
by Brother Printer Support Brother printer Support NumberIt is a great way to configure and reset your Epson printer and fix any lingering issues. This article will guide you through each step.
Resetting the Epson Printer
- Turn off the printer
- Press the reset button on the printer's back with a paperclip or tip of a pen.
- Hold the reset button while turning on the printer. Continue holding the reset button.
- After five seconds, a warning message will be printed. Press the reset button.
- Another sheet showing the factory reset IP address will be printed after about five seconds. The default address for newer Epson models is a DHCP.
Also read:: How to troubleshoot Epson printer
Configuring the Printer
- Open Safari on an iPad or other connected device to the Revel network.
- Tap Go and enter the IP address of your printer.
- Next, you will be directed to the login page. The following information is required:
- Username: Epson
- Password: *Your printer's serial number
- If the serial number is not working, you can try again using the username "Epson", and the password "Epson".
- The Configuration Navigate to the menu TCP/IP.
- The following settings can be set up on the TCP/IP settings page
Also read:: Epson Printer Customer Service
Configuration Your Epson Printer
- Get your IP address: Manual
- Automatic Private IP Addressing is used (APIPA)Disable
- Use PING to set: Disable
- IP: The printer's IP address (Revel's standard address range is 192.168.22.205 to 192.168.22.219)
- Subnet Mask255.255.255.0
- Default Gateway0.0.0.0
- Socket Timeout Valuable:300
- Tap Submit.
- Power cycle or reset the printer.
Legacy Epson Configuration
You will need to temporarily alter your iPad IP address if your Epson printer has a default address of 192.168.192.168.
- Navigate to the iPad Settings > Wi-Fi
- Tap the blueiTo the right is the connected network
- Tap manual to the right Configure IP:
- Tap on the IP address to change it to 192.168.192.100. However, any a number within the range 192.168.192.xxx will work.
- Tap Save In the upper right corner.
- Your iPad can now communicate with addresses within the 192.168.192.xxx area.
- Proceed to the configuring the printer section to complete printer configuration.
Sponsor Ads
Created on Aug 4th 2021 00:20. Viewed 339 times.
Comments
No comment, be the first to comment.