How to Replace iPad Pro 10.5” Touch Screen and Digitizer Assembly
by Arvin Apsen Cell phone repair partsStep 1: Tear down and separate the iPad Pro
10.5 touch screen and digitizer assembly
1.1
Turn off the iPad, hot air gun blowing on the screen edge to soften the frame
adhesive glue, then use a thin steel pry tool to make a gap between the screen
and the frame
1.2 Use
hard plastic triangle plectrum to slice around the gap slowly, you may need
three or more plectrums here
1.3 When
the display screen is separated, slowly pry up it from the frame on the top
side
1.4
Hold the screen with a hand, loosen the two screws on the metal bracket, and
then remove the metal bracket which covered on the flex cables with tweezers
1.5
Disconnect the four flex cables when the bracket is away, and then you may take
down the display screen assembly
Step 2: Replace iPad Pro 10.5 LCD touch
screen and digitizer assembly
2.1 Take
down the home button from the old display screen
2.11 Tear up the small piece of black tape on the home button with
tweezers
2.12 Release the connector by slicing out the flex cable with
spudger
2.13 Disconnect the two adhesive gobs with spudger which is for
holding the home button and touch ID, pry it up from the front panel. Be
careful and don’t damage the flex
2.14 Remove the home button and the touch ID assembly from the
screen with spudger
2.2
Install the home button and Touch ID assembly to the new screen, connect the
bracket back to fix the home button
2.3
Connect back the home button flex cable with tweezers and paste the small piece
of black adhesive back
Step 3: Reinstall the iPad Pro 10.5 screen
and reassemble the device
3.1
Attach a new adhesive frame sticker around the edge of new iPad screen and
digitizer assembly
3.2
Connect the four screen flex cables back
3.3
Cover the metal bracket back for fixing the flex cables and screw back the two
Phillips screws
3.4
Gently and slowly attach the display screen on the frame, slightly press each
corner and the edge, and make sure there are no gaps
3.5
Turn on the device and check the new-replaced screen about the touch
sensitiveness and App response. All process is done!
Note: the whole process will be a little
complicated for someone who not familiar with mobile device repair. We suggest
you go to the Apple authorized service center or the repair shop if you are not
confident about yourself. Just be patient and careful if you are taking the
process on it.
You may also be looking for:
For
iPad Pro 10.5 LCD screen and digitizer assembly replacement
For
iPad Pro 10.5 home button and Touch ID assembly replacement
iPad
10.5 Pro glass screen protector
Sponsor Ads
Created on Nov 7th 2019 04:11. Viewed 306 times.