When You Need to Repair or Install a New Pool Pump?

If you’re reading this article then there is a good chance that your pool pump is making noises, leaking, or just plain not working! Don’t panic when the condition of your pool pump is not good. Pump is the work horse of the pool filtration system, so it’s prone to wearing out. It’s important to determine the overall condition of the pump in order to decide between whether you need to repair a pool pump or replace it. This would help you avoid unnecessary pool repair costs. Below are given few problems to look out for when checking pump condition.

1. Pump losing suction: A pool pump’s role is to draw in water, run it through filter before pumping it back to the pool. If your pump’s pressure meter shows that your pool is not working up to its ideal capacity in relation to how much water is being sucked into the pump at a particular time, it may be losing suction. In a best case scenario, you may need to backwash the filter to remove clogging or manually clean it. It can also be possible that your suction motor is wearing out, and in that situation, you have to change it.

2. Pump shuts off automatically: If your pump motor shuts down unexpectedly it is probably due to overloading. Pump shuts off when the thermal overload protection device trips down automatically. Check and fix this problem as soon as possible as it will not get corrected on its own. Check the condition of the impeller and replace it if it has worn out.

3. Pump making grinding noises: The pool pump generally runs smoothly. A distinct change in noise levels indicates an issue with the pump motor. There could be many reasons behind the loud, uncomfortable noise produced by your pump. It could be due to cavitation, internal blockage or worn out motor bearings. If your pump is running loud, call the professionals immediately.

4. Pump leaking water: Leaking pumps can destroy the swimming pool motor. There are mainly three types of leaks that can occur at the piping and motor connection. If there is a leak on the suction side where water is pumped in, there is a possibility that it is an air leak. When the side of the pump where water is pumped out is under pressure, then it might be a water leak problem. A deficient shaft seal could also result in leakage of water where the motor is attached to the pump.

5. Pump breaking down frequently: This usually happens with older pumps. Though pool pumps should last longer, but the consistent usage wears them out quickly. The hard plastic covering outside the pump warps over time and magnetic drive motors last for 5-10 years. If your pump is breaking down frequently, it's best to replace it as soon as possible.

If you notice any of these indications that your pool pump isn’t working at its best, call your pool repair Houston company or professionals in your area immediately to diagnose the main problem. An expert pool repair and maintenance company will make sure your pool is back up in as short of time possible. Let pool experts diagnose the actual problems with your pump and help you either repair or replace your existing swimming pool pump.