Iron ore crusher manufacturers.

Learn the following knowledge points to avoid crushing equipment wear not worry, we are in fact very difficult to look at the problem is not difficult, as long as you notice it when using the details, you'll find more than others as long as you pay attention a little bit, You can do well, so you better operation of the machine!

Iron ore crusher manufacturers in Egypt

Crusher Control and coarse granularity broken shim phenomenon:
The crude break is generally used jaw crusher or gyratory cone crusher, before ore inputs, the general should be broken, not exceeding 600mm size, so, in order to effectively control the particle size, the crushing entrance, install grate 600mmx600mm of conduct effective control. Control of the particle size is reduced jaw broken endurance, can effectively protect the jaw and prevent broken truck.
General jaw broken in the discharge opening at the separator is installed, the harder to avoid mines mining iron pole, shovel teeth and so on into the broken, because the broken equipment and liners are more than five times the crushing, while jaw broken eat coarse, rough row also, little effect on the liner, but broken people spout iron pick someone care is necessary.
Ensure clean belt feeder crusher scraper clean.
Increasing the buffer warehouse and material handling channel slope:
Factors crusher friction coefficient in general are: material properties, speed and temperature, load, vibration and smoothness, which we can change is material and loading, if we change the surge bin or material transport channel slope, increasing angle 9 positive pressure is reduced, it reduces the friction in disguise f = tg9, so that you can reduce the wear of the metal wall, increase the service life, but it must be a transformation under conditions permitting.

More information can be found at: