Articles

How to Tear Down Huawei P30 Pro for Rear Cameras Replacement

by Arvin Apsen Cell phone repair parts

The Huawei P30 Pro rear-facing camera module is a replaceable part. When our Huawei P30 phone is crashed, water damaged, and the cameras are broken, we need to replace the rear camera module. This is the repair process presentation of how to replace the Huawei P30 Pro rear-facing cameras we would like to show you below. Hope this would be useful to you if you are interested in smartphone repair.

1. Tear down the battery door and take off the wireless charging coil

Turn off the phone first. Use hot air gun to blow on the back panel edge and each corner. Paste the suction cup on the battery door, slowly pull it. Use hard plastic plectrum to slice around and separate the battery door from the phone. Take it off after it is totally separated. Unbolt and remove the ten screws for fixing the wireless charging coil. Tear off the remaining frame adhesive glue, pry and take the wireless charging coil off.


2. Take down the broken rear camera module and replace with the new one

Disconnect the battery flex cable first to avoid short-circuit damage to other components. The Huawei P30 Pro rear camera module is consists of two parts. Disconnect the under part camera flex cable and take it off the phone. Remove the rubber protector on the rear camera with tweezers, take off the small metal shield for fixing the flex cable and then disconnect the camera flex cables. Take off another camera model from the phone. Place the new Huawei P30 Pro rear-facing camera module onto the phone. Just be careful and don’t leave any dust or dirt, fingerprint on the camera lens. Connect the flex cable and fix the cable with the small metal shield. Place the rubber protector back. Install another camera module back, too.        


3. Test the new cameras’ function and assemble the phone

Connect the battery flex cable firstly. Install the wireless charger chip back and fasten the ten screws. Turn on the phone and open the camera to check the new replaced camera’s function. Make sure it is working all normally. Turn off the phone again. Tear off and clean out the remaining adhesive on the Huawei P30 Pro battery door. Apply the new frame adhesive tape on the frame, make sure it is in the exact position. Assemble the battery door back to the phone, make sure it is closely attached to the back frame. All process is finished.  

 

The whole steps above are demonstrated by our professional repair team. It will take you a longer time if you are not familiar with Huawei phone repair. Also, we need to be careful and patient during the repair process. Finally, we recommend you our new Huawei P30 LCD display screen and digitizer, as well as some replacement parts if you are running a repair shop. Come to Etrade Supply if you are looking for smartphone parts.



Sponsor Ads


About Arvin Apsen Advanced   Cell phone repair parts

26 connections, 0 recommendations, 164 honor points.
Joined APSense since, May 5th, 2017, From Whittier, United States.

Created on Nov 13th 2020 00:53. Viewed 76 times.

Comments

No comment, be the first to comment.
Please sign in before you comment.