Barite processing plant Cone Crusher Africa.

Cone crusher is widely used in metal and nonmetal mines, cement, sand and metallurgical industries. Applying the crushing Platts hardness ores and rocks ≤5 ~ 16, such as iron ore, nonferrous metal ore, granite, limestone, quartzite, sandstone, pebbles, etc.

Work cone crusher crushing machine applies only to broken or minor operations. The uniformity of minor operations nesting size generally higher than the crushing operation requirements of high, therefore, in the lower part of the crushing chamber shall be a parallel zone, meanwhile, must speed up the cycle broken cone speed, so that the material in the parallel region more than once by extrusion.

Broken minor operations in comparison rough broken big job, so there is a large volume of loose increase its crushed. To prevent crushing chamber may cause obstruction, without increasing the discharge opening to ensure that the premise of the desired size of the discharge, the need to increase the overall nesting section broken by increasing the diameter of the bottom cone.

Cone Crusher markers mouth smaller, mixed with a compound of the non-broken easily cause of the accident, and because of the crushing operation of the nesting size demanding to be timely adjustment nesting mouth after the liner wear, thus cone crusher insurance and adjusting device than crushing machines operating more than necessary.

Insurance Simon spring cone crusher overloading, forcing cone shell and its own compression spring rise to increased nesting mouth, from the non-broken. Nesting mouth on the sleeve to adjust, turn the adjustment sleeve solid shell can be filled by means of the thread of its cylindrical shell driven up or down to change the nesting population size. Hydraulic cycle with the same crusher hydraulic cone crusher insurance and adjustment mode.

Cone Crusher routine maintenance

Have iron removal devices to prevent the crushing chamber through the iron, if iron is too frequent, it may cause broken shaft accident.

To full capacity, there would be too coarse granularity.

Production Line crushing ratio allocation should be reasonable, so as to maximize the efficiency of the crusher.

Spring pressure can not be too tight, too much pressure will be broken shaft accident occurs, the pressure is too small springs frequently beating, impact crusher work, product size and thicker.

More information can be found at:

sbekaolincrusher

copperorecrushermachine