300-115 Free PDF Demo

Test Information:

Total Questions: 234

Test Number: 300-115

Vendor Name: CISCO

Cert Name:  CISCO ROUTING AND SWITCHING FIELD SPECIALIST

Test Name:  Implementing Cisco IP Switched Networks (SWITCH )

Official Site:http://www.examsboost.com

For More Details: https://www.examsboost.com/test/300-115/

Question: 1

 

What is the maximum number of switches that can be stacked using Cisco StackWise?

 

A. 4

B. 5

C. 8

D. 9

E. 10

F. 13

 

Answer: D   

 

Question: 2

 

A network engineer wants to add a new switch to an existing switch stack. Which configuration must be added to the new switch before it can be added to the switch stack?

 

A. No configuration must be added.

B. stack ID

C. IP address

D. VLAN information

E. VTP information

 

Answer: A   

 

Question: 3

 

What percentage of bandwidth is reduced when a stack cable is broken?

 

A. 0

B. 25

C. 50

D. 75

E. 100

 

Answer: C   

 

Question: 4

 

Refer to the exhibit.

Which set of configurations will result in all ports on both switches successfully bundling into an EtherChannel?

 

A. switch1

channel-group 1 mode active

switch2

channel-group 1 mode auto

B. switch1

channel-group 1 mode desirable

switch2

channel-group 1 mode passive

C. switch1

channel-group 1 mode on

switch2

channel-group 1 mode auto

D. switch1

channel-group 1 mode desirable

switch2

channel-group 1 mode auto

 

Answer: D   

 

Question: 5

 

Refer to the exhibit.

How can the traffic that is mirrored out the GigabitEthernet0/48 port be limited to only traffic that is received or transmitted in VLAN 10 on the GigabitEthernet0/1 port?

 

A. Change the configuration for GigabitEthernet0/48 so that it is a member of VLAN 10.

B. Add an access list to GigabitEthernet0/48 to filter out traffic that is not in VLAN 10.

C. Apply the monitor session filter globally to allow only traffic from VLAN 10.

D. Change the monitor session source to VLAN 10 instead of the physical interface.