3 Steps on How to Replace iPhone 11 Pro Speaker

by Arvin Apsen Cell phone repair parts

The iPhone 11 Pro speaker is a replaceable part of the device. If there are problems with the speaker, you may have it replaced in the repair shop. On the other hand, you may also fix it yourself at home if you are familiar with iPhone 11 Pro teardown and reassembly. Here we would like to show you how to replace this part in three steps as follow.

1. Teardown iPhone 11 Pro display screen

First of all, we need to get a new speaker and the repair tools ready. Power off the device and loosen the two pentalobe screws on the bottom. Hot air gun blowing on the edge of the screen for easy separation. Use a suction cup and hard plastic plectrum to separate the iPhone 11 display screen. Pry and flip the display aside, loosen the two Y-type screws and remove the small metal panel as well, then the six Y-type screws and the penal. We need to disconnect the display screen flex cables and the battery cable so that we could separate the display screen from the phone. After that, we would move to the next step.

2. Replace iPhone 11 Pro Speaker

The speaker is on the bottom part of the iPhone. Firstly, we need to loosen the four Y-type screws and remove the metal panel. Disconnect the speaker flex cables and another battery cable. Loosen the three screws for fixing the speaker, for two Phillips screws and one Sandoff screw. Use hot air gun to blow the speaker on 80 ℃ for easy removable, then we can take down the speaker with tweezers. Install the new speaker on the phone and adjust it to the right position. Tighten the three screws back. Connect the flex cables and cover the pane back. Tighten the four screws for fixing the penal.

3. Reassemble iPhone 11 Pro display screen

After the new speaker’s installation is completed, here we need to reassemble the iPhone. First, we need to test the new speaker’s function. Connect the display screen flex cables and the battery cable. Turn on the phone and open the applications to test the speaker. If all the functions are normal, turn off the phone and disconnect the flex cables again. We need to paste the frame adhesive tape on the phone, then we shall connect the flex cables. Place the metal panels and tighten the Y-type screws back for fixing the flex cables. Lastly, we may reassemble the display screen, make sure no gap left on the frame and each corner.

The whole procedure may be a little complicated, we suggest you go to the repair shop if you are not familiar with iPhone repair. Besides, we offer all replacement parts for iPhone 11 models for sale. Just visit our shop on www.etradesupply.com or email to us if you have interests in our iPhone 11 Pro parts. You may leave your comments if have questions about our iPhone 11 repair process above.

replace iPhone 11 pro speaker