Is Leveling Wood Floors Really That Hard?

by Shohel Rana Online Marketing Professional

Leveling floors for hardwood or any other kind of floors can be done by yourself. The demands made on a floor leveling are not easy to meet: the suitable system has to compensate for the unevenness of the floor, in the case of floorboards the movements of the wood participate to some extent, provide an absolutely flat surface, but at the same time the overall height of the whole is not too large. If you have always wanted to know how to level an uneven wooden floor and how easy it can be then read on.

1. Evenly Level Wooden Floorboards with Liquid Screed

All this is done by a balancing mass such as the new or old floor. This is a plastic-cement mixture that is poured out on the planks in a thickness of 5 to 20 mm, where it sets to a hard but flexible surface.

The secret: The mass enters into a firm bond with the plank floor with the help of a primer and a stacked reinforcing fabric. However, to succeed in this incidentally quite expensive work extensive preparatory work is necessary. The secret: The mass enters into a firm bond with the plank floor with the help of a primer and a stacked reinforcing fabric. However, to succeed in this incidentally quite "lively" work extensive

2. Leveling Compound for Wooden Floorboards: What Should Be Considered?

It is important that the mass can not run away at any point, so all joints must be tight. The edge insulation strip, which you stick to the wall, prevents a sound bridge between floor and walls. And finally, you need to re-screw the planks to minimize feathering have to be. The edge insulation strip, which you stick to the wall, prevents a sound bridge between floor and walls. And finally, you have the

If you want to compensate for different deposits, you must install a movement joint in the leveling compound. Under no circumstances should the layer pass, otherwise, there will be cracks in the surface. Stick the transition with a Styrofoam strip.

3. The Initial Condition Of The Plank Floor

This is what the floor looked like after the removal of the old floor covering. The area under the former stove is tiled, the wooden planks are added with glue.

Instead of leveling compound, you can also create a flat surface with plate materials. For this, laying chipboards and gypsum floor slabs are available. They are to be laid without mixed mass, however, these raw soils are much thicker (from about 20 mm, floating screed from 5 mm). But they have one thing in common: they absorb it with all the rubbers.

If the floor leveling compound for wood subfloors has the right consistency, it will spread quickly around the room after the job. Depending on the condition of the soil you have to help a little with the even distribution of the mass. Stir the leveling compound quickly so that the individual quantities applied can mix well with each other. With the help of a notched trowel, you ensure a seamless transition of the individual containers.