How to Care Your SEC-E9 Key Cutting

by Jimmy LIN OBDTOOL

How to keep your SEC-E9 Key machine well and use for a long time? Here is some using tips for you.

The Power Supply

SEC-E9 Key Machine can only operate normally under DC24V/5A , if the supply voltage is more than DC24V, the unit may be damaged due to overvoltage; at low voltage, it will cause reduced motor output, resulting a incorrect positioning of the movement and insufficient cutting efforts.

The Cutter

Please change the cutter regularly, and be sure to use Kukai original cutter. This is very important.

Key Blanks

Before cutting a key, please do check whether the key blank is standard. If the key blank itself is flawed, it may not able to achieve the desired results.

Correct Cutting Speed

The material of the key blanks affects the cutter's cutting performance. Please choose the cutting speed according to the key blank hardness, this help you keep the lifetime of the cutter.

Working Environment

Do not expose the tablet to sunlight. Once the tablet is exposed to the sun for too long, the temperature will increase and the lamp in the screen will be aging accelerated, this will greatly reduce the useful life of your tablet, and the tablet may even be exploded. Please don't beat or pound the machine, don't place the machine in rain or snow, either.

Clean

In order to extend the service life of E9 meanwhile maintain the accuracy of the machine, you should always do a good job of cleaning, just removing the debris above the decoder, the cutter, the clamps and the debris tray when every key blank side done.

Regular Checking

We suggest to check the performance status of the machine every month and to clean the machine deeply. Always check the fasterning parts - screws and nuts, whether loose or not.

Correct Repair Operation

When the machine can't be calibrated, or cutting a key is not accurate, please contact the after-sales staff to replace the damaged parts or help you adjust incorrect positioning parts timely

You must conduct repair work under the guidance of our support team, you can't disassemble the machine privately. Please do remember to unplug the power plug when you doing the maintenance.

Condor mini xc

VXDIAG VXC NANO for Volvo

Auto-key-programmer