How Can You Avoid Problems With Your Water Heater System?

Neglecting the hot water system maintenance needs will make them encounter huge problems sometime soon. Even if some cost is involved, hot water systems repair and maintenance is a must. Once the hot water system encounters a severe defect, then it will surely lead to exhaustive leakage that will lead to floors and subsequent structural damage to property. Hence regular hot water system, repair and maintenance is a must to conduct. If the issues can be repaired, then make sure to hire hot water repair services from the best company in Perth to Read the guide below to keep your water heater system protected and avoid significant issues like mould growth and flooding.

 

1. Make Sure to Insulate The Pipes

Insulating pipes bring about two advantages. First, you can save on water heating expenses. Second, you can avoid frozen pipes at home. Uninsulated pipes lose a lot of heat. So, by insulating the pipes, you can better save on energy bills as the water heater is safe from overworking. At the same time, water bills are even saved as the tap need not run for an extended time period for water to heat up.

2. Backing Up Solar Heated Tank

Solar water heaters are the best energy savers. But when the sky is cloudy, then the photovoltaic device could not convert into electric energy like usual as much as solar light. So, a backup plan will be needed for heating water during cold and cloudy days.

The ideal solutions here are gas and electricity. Even the solar panels should be clean for efficiency improvements.

3. Cleaning the Tank

Well-water and municipal water contain a lot of sand, silt or small rocks. Settling down at the bottom, debris affects the water heater functionality. Contaminating water, the sediments reduce the water volume as the tank could likely hold.

Even, they clog the drain valve and cause rusting. Flush and clean the tank at regular intervals for avoiding these problems. Even if needed install a filter for sieving impurities. To prevent clogging, make sure to clean the filter or else the pipes will be damaged.

4. Keep the Flood Stop System Under Check

The flood stop system should work correctly at all times. The flood stop systems are hardwired to the existing electrical systems with the battery backup near the hot water system. There is a sensor in the water heater pan where the unit's power is turned off and the alarm is sounded on water detection. So, the floor stop system should be in the right working condition for preventing flooding and bringing about consequential damages.

5. Testing The Water Heater Valves

Gas and electric water heaters contain a pressure relief valve as a safety feature. The very purpose of the valve is opening and releasing pressure when the water is over-pressurized. To test the valve functionality, lift it halfway.

After being released, the valve must instantly snap back into place. But if it has not gone back, then you will need the repair services of the hot water repair professionals to ensure its correct performance.

All the discussed tips are directed towards improving the water heater efficiency and ensuring an uninterrupted hot water supply. We all know a properly functioning water heater is of high necessity. When the necessary repairs are done on time by the hot water repair specialists, then the cold weather issues like flooding, increased energy bills and water bills can be avoided.

No comment, be the first to comment.