Galletto 1260 flashing cable User Instructions
by Serena Kong OBD tool & service online supplierGalletto 1260 flashing cable is auto ecu tuning tool released by ADK auto diagnostic. Galletto 1260 ecu flash tool can read and write ECU with your cars. Do you know how to read and write car ECU via use Galletto 1260flashing cable?
EOBD Galletto 1260 OBD2 ECU Flashing Cable Galletto 1260
EOBD Galletto 1260 OBD2 ECU Flashing Cable Galletto 1260
How to use Galletto 1260 flashing cable read car ECU:
1. Prior to connecting the Galletto 1260 you must copy the software from the mini disc and add it to the desktop on your laptop. If you don't have the disc the software is available on the HDI-Tuning website.
2. To use the software, connect the USB end of the Galletto 1260 into the laptop.
3. Connect the OBD lead to the cars diagnostics port. This is usually beneath the steering wheel in the fuse compartment.
4. Open the programme named 'New Serial'. Wait 30 seconds.
5. Switch on the ignition key to two clicks, don't start the engine.
6. Select Peugeot/Citroen, Bosch EDC 15 C2 29f400BT.
7. Select ECU data.
8. Select read data, you can then name and save the file.
9. When finished, wait for the message (which is in a different language, but tells you to switch off the ignition and wait for ten seconds).
10. Switch off the ignition and then click ok. Wait ten seconds, then switch on and press ok.
You should now have a copy of your original file on your laptop.
How to use Galletto 1260 flashing cable write car ECU:
Writing the remapped file is very similar except you would use open file rather than read file.
1. Prior to connecting the Galletto 1260 you must copy the software from the mini disc and add it to the desktop on your laptop. If you don't have the disc the software is available on the HDI-Tuning website.
2. To use the software, connect the USB end of the Galletto 1260 into the laptop.
3. Connect the OBD lead to the cars diagnostics port. This is usually beneath the steering wheel in the fuse compartment.
4. Open the programme named 'New Serial'. Wait 30 seconds.
5. Switch on the ignition key to two clicks, don't start the engine.
6. Select Peugeot/Citroen, Bosch EDC 15 C2 29f400BT.
7. Select ECU data.
8. Select 'Open file', and then select the new remapped file.
9. Select download file. Make sure there is no other software running and no possible interruptions, don't knock the cable etc...
10. Afterwards, when it prompts, switch off the ignition once the lift pump has stopped. Then press ok and wait ten seconds.
Sponsor Ads
Created on Dec 31st 1969 18:00. Viewed 0 times.
Comments
No comment, be the first to comment.