cemented carbide indexable tool market share is lower in China than the import tool

At present, China's cemented carbide cutting tools business by constantly learning and strategic planning, has been in the market to occupy half, however, enterprises in the process of development and highlight several fatal problems, if not enough, improper handling, will seriously affect the enterprise's development and progress.

At present, carbide cutting tools in the developed countries have accounted for the dominant position of cutting tool type, the proportion is as high as 70%. While high speed steel cutter is shrinking at an annual rate of 1% ~ 2%, the proportion has dropped to below 30%.

At the same time,cemented carbide cutting tools in our country has become the main tool processing enterprise, is widely used in automobile and parts manufacturing, mold manufacturing, aerospace, and other areas of the heavy industry, but our tool enterprises blindly, mass production of high-speed steel knife and some low standard tool, completely without considering the market saturation and the enterprise needed, finally has a high-tech and high value-added high-end cutting tools in the market "given" to foreign companies.

The data shows, at present, the cutting tool in the annual sales of about 14.5 billion yuan, the carbide cutting tools account for less than 25%, of carbide cutting tools for domestic manufacturing has accounted for more than 50% of the cutting tool, the blind production has serious can't satisfy the domestic manufacturing of carbide cutting tools growing demand, thus formed the high-end market in a vacuum, eventually dominated by foreign companies.

From the point of current usage, domestic cemented carbide indexable tool market share is lower than the imported cutter, investigate its reason, mainly include the following: 1. The product quality consciousness is not strong domestic producers lack the quality consciousness of some tools. China-made indexable insert material quality is poor, less varieties, the specification is not complete, the increase in the quality of the product is difficult to tools. Look from the appearance quality of the product, the import tool appearance, color and texture is superior to domestic tool. On product performance, compared with domestic knives, imported cutter machining high dimensional accuracy, good stability, high durability, high removal rate, tool and its accessories have good interchangeability, after the general assembly can meet precision requirement. 2. Incomplete pre-market after-sales service abroad many tool company has included for the user to choose knife, knife, timely replacement of supply,, as good service, and many domestic tool vendors do very not enough in this aspect, the service is simple and extensive. 3. The mode of production of small workshops still accounts for a large proportion because of the economic and other reasons, some domestic tool factory still accounts for a large percentage of small workshops production mode, the processing personnel technical level is low, simple equipment, difficult to guarantee the quality of the product. Caused by tool cutting tool parts processing and assembly quality products of some quality common fault is still difficult to eliminate.

Sponsor Ads

• Ad Space Available - Rent it Now!

Report this Page

Created on Dec 31st 1969 18:00. Viewed 0 times.

Share on APSense

Comments