Tips to Repair a Laptop LCD Monitor

For those who have a laptop LCD monitor, you might find the Liquid crystal display is degrading or beginning to malfunction. Even additionally, there are some serious problems like vertical lines or bad pixels around the LCD panel which should not be fixed so the only solution id to change the whole LCD panel. However, some common problems like black screens, flickering, and dimness still could be repaired. Before you begin, it is necessary so that you can diagnose the issue correctly. You should check out the following advice which will direct you to fix a laptop LCD monitor.

As the initial step, you need to turn your laptop off. Just wait for a couple of minutes and you then can unplug the AC cord from your wall outlet. Following that, you need to take away the battery from the dock beneath your laptop. It is necessary so that you can not try to the dismantle components using the source of energy. Before you begin it, you need to wear an anti-static wrist strap.

The next step you need to do would be to take away the screws from your plastic frame that bordering the LCD panel. This frame is also referred to as the bezel which supports the screen within the place with screws that make reference to the item documentation to put and undo all screws. For a few types of laptop, it is needed to dislodge small rubber seals to be able to expose the screws underneath. Use a flat-tipped implement for taking out the rubber seals.

The 3rd step would be to pull away the frame. Just put the guitar pick involving the plastic frame as well as the glass top of the LCD, and you have to gently work your path all over the frame.

The 4th step would be to locate as well as look into the two cable connections. The LCD screen is attached to the small green inverter board using power cable, which is attached to the motherboard via video cable. Within this step, you have to unplug the cables from your screen and after that attach them again. Following that, you need to turn the computer monitor on and look it. In the event that the computer monitor has same problem, you need to replace the inverter or even the backlight.

The fifth step is to determine the connections as well as the components before you will reattach the frame. You must make certain that the inverter board is firmly located in place as well as the cables are connected properly. Then, you are able to put back the screws onto attach the bezel round the screen.

Finally, you are able to turn your pc on. You need to ensure the LCD can display the brilliant images without flickering. Otherwise, it is needed to replace the LCD panel.