Things To Know When Cleaning a Sliding Glass Door

Hello and welcome to my first article! I would be delighted and will certainly appreciate if you like and comment after you are done reading. Only if you found the article worthy of your attention, of course! Today I shall share how to clean that pesky glass door, be it near the kitchen or inside the bathroom.

It's essential to keep your sliding glass door clean at all times. One of the main reasons to do this, is because the dirt and smudges are a lot more visible on the glass surface, than on the regular wooden doors. Also, having a clean glass door can open up the room, providing you with the needed natural light and keeping the outside view clear.

It is imperative to first saturate the entire surface of the glass door with a mixture of soap and water. Use a clean rag and run through the whole door, this will help a lot with loosening the stuck dirt. Needless to say, this will make the cleaning process a lot easier in the long run. It would be best if you work on one side of the door at a time.

The solution needs to soak for several minutes, share practitioners of cleaning services in London, after which, you can just wipe it off with a clean cloth or regular paper towels. The next step would be to grab some mild solution for window washing. When you get your hands on this important chemical, it is time to apply it with a non-abrasive tissue. A microfibre cloth works best, although a foam sponge can do the job quite nicely, too. A quick tip: when you start applying the solution, make sure to start from the top, going to the bottom. This way, the liquid will stream down to uncovered areas.

You will need to remove the cleaning solution with a squeegee right after you finish covering the whole glass door. By letting it stay for too long, you risk leaving unpleasant blotchy spots on the glass or creating some streaks. Removal should happen the same way as the application - from the top to the bottom.

The majority of cleaning services London advice to dry anything that got wet during the procedure. Most often, those are the frame of the window and the floor. Some paper towels or a clean rag would be the best tools for this job. Do not forget this important bit, though - you should not dry the glass part of the door. First of all, it should be almost completely dry after the squeegee treatment. And second, the liquid which remains should air-dry by itself.

After those steps are followed, your sliding glass door should be as clean as new! The whole process shouldn't take you more than an hour, if the door has two parts. Be warned, however - using any scrapping instruments to remove the harder stuck debris will result in permanent damage on the glass surface. If such problems exist, just repeat the first step. After a few tries, everything should fall off. Happy cleaning!