Method and maintenance of common problem of tap

1 brass bath taps uk water or water to reduce the bifurcation without bubbles.

Possible reasons: bubbler filter fouling or impurities such as scale dirt blockage.

Solution: remove the tap, clean the filter.

2 shower water is small, water branch

Possible reasons: low water pressure or Bathtub Taps with debris clogging or scale accumulation.

Solution: remove the shower nozzle out of shower water inlet and a water outlet with filter rubber washer or washing shower top spray to clean up.

3 Antique Shower taps

Possible reasons: high pressure; leading handle snap shut; hot and cold water pipes fixed bad; on the water inlet pipe hinder or scale.

Solution: to reduce the pressure, avoid rapid closure of leading to the construction, pipe cleaning, check the pipes and connecting objects (such as water purifier, water heater) there is bad.、

Water tap not overexert, gently rotate homeopathy. Even the traditional tap, also do not need a big effort to tighten the dead. Especially do not handle or use as a handrail to support.

A metal hose should keep the bathtub tap natural stretch, need not be coiled on the tap. At the same time, when not in use or not, pay attention to the joint and the body of the dead hose formed, so as not to break or damage the hose.

Under the pressure of not less than 0.02MPa (i.e. 0.2kgf/cm2). After using a period of time, such as found that reduce the amount of water, and even the emergence of the phenomenon of water heater flameout, in the water outlet of the tap lightly unscrew screen cover, remove impurities, usually to recover.

When installing, taps should be as far as possible not to bump with a hard object. Don't keep cement, glue, etc. residues on the surface, so as not to damage the surface gloss of coating. Should pay attention to in the pipeline debris removal after loading on tap.

For more information about uk taps , please visit www.cheaptap.co.uk/