Know How To Install A Coax Cable Connector And Its Fittings

Installing a coaxial cable is not a very difficult job and if you know about the end fittings well and with a little bit of practice you will find it a very simple process, much easier than you thought. You simply have to get the hang of it and make sure that you buy a few extra of coaxial cable end connectors. The basic tools required for coaxial cable installation are crimp tool for crimp fittings, a compression tool for compression fittings and a good quality set of wire cutters. This is essential to cut the cable as it will ensure that the cable is cut clean and not crushed inside. You will also have to use the wire strippers for better fitting.

If you do not know how to install a coax cable connector then you should follow some simple steps. Start with adjusting the coaxial cable end wire strippers. This is necessary to ensure that the first cut is perfect and cuts till the copper wire at the center. After that you will have to make a second cut precisely so that it cuts only through the rubber jacket and make sure that you do not cut the wire braiding which lies just below the rubber jacket. You will have to take several attempts to adjust the tool perfectly so that each of these cuts are proper and as desired.

Now comes the time when you have to insert the coaxial cable into the strippers. Care should be taken that proper adjustments are made prior to the insertion so that the end of the coaxial cable is flush along with the stripper edge. For best fit and result you should spin the stripper around the cable to make sure that it is free enough to turn. You will also have to pull it away from the cable and squeeze the jaws of the stripper slightly on the cable to ensure perfect fit. Now the cable is ready for installation with the best cell phone repeater.

The connector and crimp must be fitted properly so that you get the desired result. You can take help of professionals who know how to install a coax cable connector or even take help from the internet for a step by step instruction. Just makes sure that the braided wire is folded back properly over the rubber jacket to prepare the coaxial cable properly before fitting. Slide the cable connector to the cable with the help of a plier if it does not slide easily.

There is a white insulator around the center copper wire and this should flush with the hole inside the connector. This is now to be fitted to the cable insert and the handle is to be squeezed to ensure proper fit of the crimp on the cable. Please note that you can use it again once you crimp and compress the coax cable end.

Report this Page