Introduction in common bond agent

1. The resin bond (B) bond itself good elasticity, polished effect, easy to burn at a high temperature binding agent. Resin abrasive sharp from good performance, easy to plug; and then after a little trimming dressing, high grinding efficiency, low grinding roughness, grinding temperature is low, the resin bonded abrasives superior performance, its super abrasive Abrasives are used widely. Resin diamond abrasive used in carbide cutting tools and steel bonded carbide parts and some non-metallic materials, semi-fine grinding, grinding. CBN abrasive grinding resin is mainly used for high vanadium high speed steel cutting tools, tool steel, tool steel, stainless steel, heat-resistant alloy steel semi-fine grinding of the workpiece, grinding and so on.

2. vitrified (V): vitrified high strength, heat resistance, cutting sharp, high grinding efficiency, grinding process is not easy fever and congestion, the amount of thermal expansion is small, easy to control the precision and easy dressing . Vitrified bond typically used for roughing, semi-fine grinding, the large contact area of the form grinding, superabrasive grinding sintered body.

3 metal binding agent (M):. Metal bond are two bronze bond and electroplating bond. Bronze bond rigidity, high strength, wear resistance, long life, good shape retention, can withstand a greater load. But poor self-sharpening, easy to plug fever, difficulty dressing. Bronze bonded diamond abrasive is mainly used for coarse grinding and cutting glass, ceramics, stone, concrete, semiconductor materials and superhard materials and other metal materials, a small amount of carbide for roughing and profile grinding and various honing material. Higher plating bond strength. Its thin abrasive grit density, surface grinding wheel cutting sharp, high grinding efficiency, good economic returns, without finishing, abrasive but short life. Electroplating main binding agent for the production of complex shape forming abrasive, small grinding, nesting knife, cutter, cutting blade, and a high-speed plating reamer into grinding mode.

4 plating binding agent: higher strength, the abrasive layer is thin, high-density abrasive grinding wheel sharp cutting surface, high grinding efficiency, good economic returns, without finishing, abrasive but short-lived. Electroplating main binding agent for the production of complex shape forming abrasive, small grinding, nesting knife, cutter, cutting blade, and a high-speed plating reamer into grinding mode.

5. The rubber bond: from natural or synthetic rubber and compounding agents made bonds.

 More product message pls visit our website:www.3betterdiamond.com