Installing an Air Cooler

Evaporative coolers work on the principle of heat absorption by using the process of water evaporation. The machine works by pulling hot air from the atmosphere into the wet pads. The cool air generated is circulated into rooms with the help of the fan. 

Most people install their coolers on roof and fix blowers that push the air through a discharge cooler. Installing the machine on the roof top is cheaper but it has several disadvantages. Some of the disadvantages include getting on the roof to maintain the machine, leak in the ceiling and corrosion of the framework that is built to support the cooler.

Before you install an evaporative cooler you must decide on the location and mark the opening. You must then construct a platform of iron or wood and attach the platform to the opening. When fixing the platform, make sure you don't cut any structural framework. The size of the opening and the structure will depend on the instructions that come with the machine.

Once the platform has been fixed, lift the home air cooler and place it on the platform. Read the instruction manual that comes with the cooler to check the spacers that can be used between the cooler and platform. It is a good idea to support the machine with wires to prevent winds from damaging your machine.

Check the size of the water tube you will need to connect the machine to the water source. You can use saddle valve to connect the tube to the water supply as it will ensure uninterrupted supply of low volume water to the cooler. After connecting the tube, you must connect the electric wires to the power supply with the help of the right conduits.

If you have brought a new unit, you must attach the motor and adjust the tension of the belt. When you buy an old unit, motor is usually attached and you have to make small adjustments to the fan belt. After fixing the fan belt and the motor, you must make sure the vents are open and the ducting is installing properly. Now turn on the water and set the water by making adjustments to the float valve. Once all the connections are checked, you can start the cooler and adjust the vents to get the desired air flow.