How to Setup a HP Office Jet Pro 8028 Printer?

Posted by Jone Smith
1
Dec 15, 2020
470 Views
Image

Among all the printer manufacture companies HP has set its position among the best 3 of them. HP believes in technology advancing and keeping their customers happy. Thus, HP has unending customer support with them.

But the point is, it doesn’t matter which manufacturer’s printer you are using, there will be some issue which are too common for every printer. Same goes with Office Jet printers. The biggest issue is to set it up properly.

If you can’t find how to setup a HP office jets pro 8028 printer then you have three ways to go:

·         Read this article!

·         Contact HP printer support in Hawaii

·         Or you can contact on a toll free number - +1(877) 894-5316

Let’s get back to learning for now –

Step 1: Time to Unbox the Printer –

·         The first step is to take out the printer out of the box.

·         Now you can remove the film from the control panel of the printer.

·         Now, remove the tapping from the printer.

·         After performing the first step, you have to lift the lid scanner.

·         Now remove the packing material from the scanner glass.

·         Take out packing material from scanner bed.

·         Now, close the scanner lid.

Step 2: Connect the Power Cord and set Preferences

While, connecting your printer power cord you have to make sure that you do not connect a USB cable at this time.          

·         You have to connect the power cord to the back of the printer and into the power supply.

·         Now, connect the power cord.

·         After connecting printer to power supply, if your printer doesn’t start you can press the power button to switch it on.

·         You can select your language and confirm it on the printer’s control panel.

·         You also have to select your country and confirm it.

Step 3: Install your ink cartridges

·         After connecting your printer, now we will install the ink cartridges.

·         WE have to open the front door, and lift the ink cartridge access door.

·         Open the printer doors.

·         Now, you have to wait for few seconds until the carriage stops moving and you can continue.

·         Now, carefully remove the protective plastic from the carriage.

·         Pull the orange pull-tab straight back to remove the entire plastic wrap.

·         By pulling the orange tab on the wrapper straight back, you have to hold the ink cartridge by its side.

·         Now, twist the orange cap counter clockwise and remove the ink cartridge.

·         You have to twist the orange cap to break it off the cartridge.

·         Now, slide the ink cartridge into its slot, and press down on the ink cartridge until it sets back into place.

·         Install the ink cartridge and repeat the above steps for other ink cartridges.

·         Close the front door and the ink cartridge access door.

Step 4: Load Paper into the input tray

·         You have to slide out the input tray, and remove all kind of packing material.

·         Slide out the paper guides and open the input tray by sliding out the paper guides.

·         Now, load the plain white papers into the input tray with the little edge forward and the print side down.

·         Now, slide in the paper width guides and insert the input tray into the printer.

·         Select ok on the printer’s control panel.

·         Open the scanner lid; place the alignment page on the scanner glass.

·         Now you have to place the page face down near the back corner of the scanner glass.

·         You have to close the scanner lid, and then touch Scan now.

·         The printer scans the alignment page, and a successful message will be displayed on the control pane of your printer.

Now, the final step is to you having to install the printing software.

But in case, if you still have problems you can easily contact printer support in Hawaii or contact the toll free number - +1(877) 894-5316.

Comments
avatar
Please sign in to add comment.