How to remove Instrument Panel from Inside the Cab on Scania P,G,R and S series
by Ji Xiaohui vehiclerepair22This instruction will show you guide on how to remove instrument panel working from inside the cab on Scania P,G,R and S series.
Preparation:
Scania XCOM V2.30 V2.27 Dongle Emulator Free Download
Scania XCOM V2.30+Dongle Emulator Download & Installation Service
Procedures:
Remove the A-pillar panels.
Remove the covers on the driver's side.
Remove the covers on the passenger side.
Remove the lower storage compartment.
Remove the bracket to the lower storage.
Remove the defroster panel.
Remove the upper attachments of the instrument panel in the firewall.
Remove the pipe to the exhaust air vent, left-hand side of floor.
Detach the vertical steering column at the top.
Remove the cable harness and air supply on the driver's side.
Remove the door cabling (C14 and C18), floor cabling (C12, C20, C78) (and C8015, if fitted)
Remove the screws (C14 and C18) and floor cabling (C12, C20, C78) (and C8015, if fitted)
Attach the ground cable to the instrument panel cross member with cable ties.
How to Install Scania XCOM V2.30 Diagnostic Software
Remove the cable harness and air supply on the passenger side.
Remove the door cabling (C9, C25 and C218)
Remove the cable harness for the roof shelf.
Remove the cable harness and the central electric unit for BWE, between the instrument panel and floor lead-through.
Remove the compressed air supply, screw and electrical ground point (G).
Attach the cable harnesses for the door and roof shelf with cable ties to the grab handle. Attach the ground cable to the instrument panel cross member with cable ties.Sponsor Ads
Created on Jun 16th 2021 02:10. Viewed 311 times.