Articles
How to Install and Removal Governor,Rear Pump for Automatic transmission Mercedes-Benz 722
by Ji Xiaohui vehiclerepair22This instruction will show you guide on how to install and removal governor, rear pump for automatic transmission Mercedes-Benz 722
Preparation:
Benz DTS Monaco 8.16+Database Installation & Activation Service
How to Install Mercedes Benz DTS Monaco 8.16 Software
Procedures:
Screw out drain plug(4a) and drain oil
Installation note: Tighten drain plug to 14Nm. Check oil level and correct if necessary.
Remove cross member(22) together with rear engine mount.
Remove companion plate(25)
Unplug lamda sensor cable(arrow) on tunnel and disconnect mounting clips.
Completely remove exhaust support(24)
Engage parking lock
Unscrew twelve-sided collar nut(62) and pull off joint flange(64)
Installation note: Tightening torque is 12Nm, then knock the collar into the recess on the input shaft(arrow) with a suitable drift.
Benz DTS Monaco 8.16 8.08 Software Free Download
Take off disc(65)
Unscrew bolts(71), and take off rear cover(70)
Caution:
When removing the rear transmission cover, be sure that the kickdown solenoid valve is not damaged. It may be necessary to loosen the kickdown solenoid valve and turn slightly.Sponsor Ads
About Ji Xiaohui 
vehiclerepair22
8 connections, 3 recommendations, 77 honor points.Joined APSense since, September 3rd, 2020, From xiamen city, China.
Created on Aug 22nd 2021 20:55. Viewed 257 times.
