Here are a couple of pointers

Posted by Lin Xia
1
Dec 20, 2012
586 Views
to do it. At the 456engleien Ft. Lauderdale Boat Show, I talked with spokespeople from Interlux. The rep told me that both the Interlux brand of topside paints and the Awlgrip brand are very synonymous in preparation and practical application. Interlux, even so, is formulated for the do-it-yourselfer. So my choice was made, Interlux Perfection, two part paint was the way to go.Without going into detail about what the directions state, let me just say that although working with two-part paints looks frustrating, it really very simple to do. Just stick to the directions supplied with each can of paint and you'll get the hang of it モンクレール 店舗 immediately.I selected the roll and tip technique of practical application as spraying in a marina was impossible. It easy to do once you practice. I practiced on a scrap piece of glass until I had it down pat. Instructions are supplied by Interlux.Here are a couple of pointers.Begin your project by separating the used trawler or motor yacht into workable sections; that way the project will not overwhelm you. I selected the port bow pulpit on the Patricia Ann to start my plan.Preparing the surface to be painted takes about 3/4 of the time you will spend on your project. A bad surface will create a bad paint job. Start by cleaning the gel coat with thinner. This will rid the gel coat of any silicon that may have been applied that will make the paint lift after application. The next step, take a little hammer and check out the entire area to be painted, taping to find any voids below the gel coat. When you find them and you will, grind them down with a Dremel tool. You don't want to spend the money and time to do a good paint job and have voids open up later on.I used the West System epoxy resin with the fairing filler to repair the voids I found. Follow the directions provided to make the resin simple to use. Sandpaper

モンクレール アウトレット them flat after the restored spots have dried. Rinse the dust off with water.The hard part is not over yet? Now we must tape the region that's going to be painted and take lienglel921 off any hardware to cause it go easier. I applied the 14 day painter's tape in stock at Lowe's or Home Depot for masking.Now it time to paint. I used a 4 inch foam roller and the best

2-1/2 inch natural paint brush I could find, also in stock at Lowe's. Mix just enough paint that you can use in 2 hours, for me its 1/2 quart. The paint is pricey, about $85.00 a quart and you don't want to be throwing any away.Only apply paint when the outside humidity is 75% or lower. Be certain there is no chance of rainfall.The paint takes about 5 hrs. to fully harden. Be careful to complete your paint application no later than noon to provide complete drying. If dew settles on your paint, the moisture will turn the high gloss to a dull finish. I use a window between 10 AM and noon to paint.All said and done, it took at least 600 hours to prep and paint the Patricia Ann. We used about 1 gallon of West System resin and 12 quarts of Interlux Perfection to paint two coats on her.Was it worthwhile? Absolutely! She looks beautiful!If you have been contemplating the painting of your used trawler or motor yacht and

2013モンクレールメンズ would like to ask me some specific questions, feel free to ask.Pet photography has continued to grow faster and faster as the number of pet lovers increases. Pet television ads have continued to expand knowing that there is a huge market of pet lovers out there with plenty of disposable income. Many of these pet owners have a special wall in their house

more from:

http://www.babbeldoos.nl/node/176163

http://bifoba.org/national/node/91542

http://www.go2album.com/pg/groups/1061033/these-are-just-a-few-of-the-examples-of-what-the-woman-needing/

Comments
avatar
Please sign in to add comment.