Fault Cause Of Jaw Crusher Flywheel

Description: The eccentric shaft end of jaw crusher is installed flywheel device. The flywheel in jaw crusher has the well static balance function, which can store the energy conversion, and flywheel drives the eccentric shaft operation. But the flywheel in operation process will also have some problems, what is the fault cause of jaw crusher flywheel? Next,you will understand in detail.

Flywheel Appear Idle Phenomenon

The jaw crusher eccentric shaft rod device damages, leading elbow board lost support, pull rod spring failure, and the toggle plate slide out from a draw rod supporting block. Due to the heavy work load of toggle plate, the toggle plate fractures, the particle size can not be adjusted, resulting in <a href="http://www.theabilitynet.com/application/index.html">crusher machine</a> downtime. Then we must inspect the run of elbow board relevant parts and timely adjust. The toggle plate is replaced with a new unit and then install.

Flywheel Swing Anomaly

In the process of continuous long time of crushing material, broken materials roll into the wheel inner, making wheel shell of grooved wheel cracking. At the same time, fly wheel hole, belt wheel, flywheel key, bearing wear, cause that the related main parts is loose, and the fly wheel tensioning sleeve appears loosen and machine casting. This will lead the flywheel of jaw <a href="http://www.theabilitynet.com/">crusher machine</a> to appear the phenomenon of excessive swing. When the flywheel swings abnormal, the staff must immediately stop running of equipment, to repair, and to increase the machine grooved wheel protective cover, replacement of the eccentric shaft and grooved wheel in time.

Bond Between Flywheel And Pulley Loose

The connecting key between belt wheel and the flywheel is loose or broken, and no connection. The belt pulley and the flywheel is not synchronous operation, leading to the flywheel and the eccentric shaft cannot rotate simultaneously, flywheel can’t drive the eccentric shaft. The remedy method is to check the flywheel connecting keys. If found loose or damaged, it should be repaired in time to treatment, and ensure that the wheel and the eccentric shafts running synchronously, equipment can operate normally for crushing.

Report this Page