Excellent mining machine

premium brand, mining machine for you to explain the characteristics of baghouse operation patriotic campaign has continued to heat up, I produced a bag filter dust collector there, pulse dust collector, each for a different equipment. Baghouse operation which can be divided into commissioning and daily operations. In the test run, a single component of the system must be checked Stone Crusher In Maharashtra; in the daily operation, should carry out the necessary checks, in particular to check on the baghouse performance. In the dust of use, should pay attention to the impact of changes on the host device load precipitator performance. After the dust operation, should pay close attention to the working conditions of bag filter, make relevant records work.

First, the commissioning of the new baghouse test run, should be particularly careful to check the following points: First, the air volume and pressure and temperature for each test point and the design are consistent; the second is installation of the filter bag after use , whether there is out the bag bag, let go, wear occurs, put into operation to determine by visual inspection of the chimney emissions; third is to pay attention to the existence of the bag room dew, ash system is smooth. Pay attention to prevent clogging and corrosion occurs, it will affect the production of a host of severe fouling; four is to adjust the cleaning cycle and cleaning time. This work is an important factor about dust capture performance and operating conditions.

Cleaning time is too long, it will be cleared off the attached dust layer off, become bag leakage and breakage causes; cleaning time is too short, the dust bag is not yet clear drop off, work on the restoration of the filter Mumbai Crusher Plant For Sale, it will drag fast recovery and gradually increased, ultimately affect its results. When commissioning, you must dust properties, dust concentration, a new baghouse careful study, and according to different cleaning methods to determine the cleaning cycle and time, and adjust the parameters in the commissioning of the cleaning, in order to achieve the best results. At the beginning of the commissioning period of time, often there will be some unforeseen situation beforehand, such as abnormal temperature, pressure, moisture, etc., and will damage the new device.