Do Not Ignore the Use Laptop Battery

The battery is a "consumables" and the degree of wear of the battery depends on the correctness of the operation performed when you use the battery, the operation mode, the operating frequency, the working environment temperature, stock time (unused batteries) Factor .

1.Battery charge and discharge times is directly related to the battery life, only about 400 to 600 times the general lithium battery charge and discharge times, improved products, but 800 times, each rechargeable batteries to use the end of a step forward. (When it is less than 85% charged battery charge, will be recorded and to increase the number of primary charging.) To this end, when the battery voltage is greater than the battery management procedures set charge 96% of initial value, and you currently located spaces 220V AC power, you should try to use the AC power to minimize the number of battery charging to extend battery life. The battery does not have to be removed from the machine, because the boot will not charge the battery power is greater than 96%. But even so, if you are using AC power for a long time and rarely use the battery, it is recommended, or the battery is removed from the machine better, causing some damage because of the heat generated in the long-running laptop batteries.

2.Power for 3 to 5%, it is timely to charge the battery, or the battery self-discharge phenomenon will cause over-discharge and damage the battery and charging at the machine can be shut down, suspend any state, while charging side with . The charge must be full time, otherwise it will damage the battery. Such as charging machine at shutdown or hibernation when charged to a 3 to 4 hours after the green power status indicator is no longer beating, reached 100%, should be promptly disconnect the AC power plug to prevent excessive battery charging while damage the battery. Charging machine at wait, hang, or through charging status when charged up to 3 to 4 hours after the green power status indicator is no longer beating, the battery will automatically exit charge state. The charging process will be fast charged when the power status indicator yellow (Always), charges up to a certain value into the slow trickle current charge, when the power status indicator color becomes flashing green ; been filled with 100%, it becomes green (Always). Lithium battery charging process is the constant voltage charging starts shortly voltage, i.e., will be stabilized, and the current is getting smaller and smaller.

3.Before the battery is not fully depleted (ie electricity 5-100%), not the battery charging, otherwise it will shorten the life of the battery. When electricity for 5 to 95% should be used when the battery work, so when using the AC power adapter battery will be charged (through charging status).

4.When electricity for 96 to 100% or the battery has been moved out of the machine, boot to run, use the AC power adapter and use the AC power adapter, you plug the AC power adapter's DC output plug into the machine , and then provide AC power plug into the outlet of 220V ~; should first unplug the AC power plug and then unplug the AC power adapter's DC output plug machine to remove the AC power adapter. Otherwise might damage your equipment. When using the AC power adapter when the AC power plug into 220V ~ socket on the power status indicator on the machine is not yet kindle (Note:) please press the power button for about 5 seconds during boot; shutdown or into hibernation, in addition to the green power status light all other lights are off, and unplug the AC power plug from 220V ~ socket in a timely manner, about 5 seconds after the AC power plug is pulled out, the green power status indicator goes ; (if necessary, from time from the machine and unplug the AC power adapter's DC output plug, the battery will not be through the AC power adapter reverse discharge.) or will overcharge the battery causing damage to the battery. Due to the off state where the AC power adapter is still non-detached state, is to charge the battery. If you pause the machine into standby or suspend state, do not unplug the AC power plug from the outlet of 220V ~; therefore when the machines still have the power to maintain. (Not recommended for a long time to make the machine into standby or suspend state, to take good care of your machine.)

5.If the battery is a long time (several months) do not remove the saved backup from the machine. About a month and a half of battery discharge and charge order to improve the status of your battery to increase battery capacity.

6.If the battery is not a long time, should be power set to 30 to 50% after storage, recommended about a year to a battery charge, and its power set to 30 to 50%, to prevent over-discharge and damage to the battery. The specific methods of operation of the battery is set to 30 ~ 50% as follows: When the battery power is greater than 50% power to the 30 to 50%, bootable. If the power is less than 30%, the first boot power consumption to 3%, recharge to 100% and then boot the power consumption to 30 to 50% can be.

7.Do not the battery on the hot and cold environment, the battery performance will be temporarily reduced. Should be at the to save standby and save the state of the battery is placed in the lower temperature, the battery, the optimal temperature range of about 10 to 20 degrees Celsius.

8 .set on charge starting value adjustment charge starting value, the power plug icon in the system tray (When you use the AC power) or white large battery icon (click / select Improve Battery When you use the battery power) Health / modify the value of the Start charging when below. Do not extend the charge with the cycle and deliberately altered significantly charge the battery management program set the starting value; When you charge starting value set (for example, 80%), while using the AC power adapter with battery "charge with the cycle may take up to three or four months, but if the battery is bound to have its re-activation process, or the state of the battery and the poor capacity. It will instead increase the number of charging, and to shorten the battery life. Furthermore, the battery about every one and a half months, need to conduct a discharge and charge order, and that charge starting value set (for example, 80%) after the extension of the charge with the cycle will be even more meaningless. Battery is fully charged, the phenomenon of self-discharge capacity fell to 96% usually lasts about 50 days, while the battery is just about a month and a half need of a discharge and charge order, it is apparent, IBM is charging from the default starting value of 96% is not unreasonable. However, with the aging of the battery, the battery is fully charged due to the phenomenon of self-discharge capacity fell to 96% of the time required may be shortened, then it is necessary for us to charge will be starting value slightly down, so the time just a month and a half or so.

IBM ThinkPad notebook computer information technology indicators marked "battery" vendors measure under unspecified conditions, the indicators can not be achieved under the conditions of normal use notebook , for example: information technology indicators marked "battery use time is 4 hours, in normal use, we only get about 3.5 hours of battery power supply. If you are very far, but are still under warranty, Please contact IBM.

Australia Laptop-battery-batterysale.net.au ====
Toshiba PA3534U-1BAS Battery

http://www.batterysale.net.au/Toshiba/Toshiba-PA3534U-1BAS-battery.html
Apple A1189 battery
http://www.batterysale.net.au/Apple/Apple-A1189-battery.html
hp Pavilion dv9000 Series Battery
http://www.batterysale.net.au/hp/hp-Pavilion-dv9000-Series-battery.html