BTMA-What To Do If The Output Of Oil Press Equipment Is Reduced?

The oil press equipment can be used to squeeze a variety of granular oils such as soybeans, cottonseeds, peanut kernels, sesame seeds, rape seeds, and small wild vegetable oils. Decrease, so it should be resolved and eliminated in time. Reasons and solutions for the decrease in output of oil press equipment.

(1) The raw materials are not cleaned enough, and sand and sundries enter the press chamber.

(2) If the screw shaft is polished, the parts should be replaced.

(3) The speed of the screw shaft is too high or too low, and the speed should be adjusted until it meets the requirements.

(4) The screw shaft or the cake outlet is not smooth, which affects the feeding and output of the cake. It is necessary to use a grinding wheel or use a material with a high friction coefficient such as chaff to be mixed into the cake, add appropriate water, and start the machine to slowly feed and press , Polish the snail out of the cake.

(5) The cake is too thin. This is an operational problem. The pressing of different oils has certain requirements for the thickness of the cake. The thickness of the cake should be based on different raw material conditions to ensure the output of the press. All models of oil press equipment have theoretical output. Generally, the actual output is higher or slightly lower than theoretical. Too much low is an abnormal phenomenon, which can be eliminated and solved based on the above reasons.

Report this Page