Pulling Fiber Optic Cable - Tips and How To Advice
Buildings- Although it is not necessary to run the fiber through innerduct, many people prefer this to keep it clean and professional looking. If you prefer not to use innerduct, try to keep your pulls as straight as possible. Pulling diagonal is OK, but it will make for a neater appearance if your optical switches is running parallel. Get it done right the first time. If someone is unhappy with the appearance, it will take much longer to correct, or re-pull the fiber. (Tip: Never pull around corners, even if you have a helper. You should always pull out the excess fiber to the corner, laying it down in a figure 8 pattern as your doing it. Then flip the whole bundle over and continue to pull on the other side).
Conduits- It is important to plan ahead, especially if your planning on pulling the fiber through underground conduit. Just like measuring the fiber, optical switch very important to get this done right the first time. A general rule of thumb is to use a 1.5" to 2" conduit for the fiber pull. If your running long distances, or using a thick armored fiber, you may want to increase the size to 4". It may also be a good idea to plan ahead and install a second conduit if you plan on future expansion. (Tip: Minimize the number of bends in your run. The fewer bends there are, the easier the pull will go. If you can't get around it, install junction boxes. Also make sure to protect the fiber by putting plastic bushings on the end of the conduit).
If you’re looking to buy optical amplifiers for sale, Fibermart is your reliable manufacturer and supplier of high-quality amplifiers.
Headquartered in Hong Kong, Fibermart also sells fiber optic cables. They work with various clients worldwide to meet their needs. Get in touch with them today to buy optical amplifiers of all types.
Advertise on APSense
This advertising space is available.
Post Your Ad Here
Post Your Ad Here
Comments