A Complete Step by Step Guide on How to Quickly Fix a Wet iPhone X
There are approximately
millions of users of iPhone X around the world. The Apple device is known for
its smooth functioning, features, quality of display and touch and camera
quality. That is just some of the feature or benefits of using an iPhone X. The
device offers a lot more than it cost. But, unfortunately, like any other
electronic device, iPhone X also face technical issues. No matter how hard you
protect it, yet sometimes they slip off your hand and suffer a fall. Or
perhaps, you have also met a situation where your iPhone slipped into the
water, or accidentally you spilled water on it. If you are facing a situation
where your iPhone is facing water damage then immediately follow these steps.
Quick
Tip:
You can always find iPhone water damage
repair in Singapore easily
Step
To Follow
a. Get
Your Phone Out Of Water: First and foremost, immediately take out your
phone from water. Next, keep your iPhone X is a clean, dry and safe place.
b. Never
Turn On A Wet Phone: Many people make this mistake of “turning on the phone
as soon as they get it out”. It is essential to understand that like any other
electronic device your iPhone has internal circuits that would be affected if
current runs through them if they are still wet. Turning on the phone while it
is still wet would burn out the circuits.
c. Disconnect
It From Battery: In case your phone is always on after taking a dip into
water then turn it off. Take out the battery and stop electricity from flowing
through your iPhone. As discussed earlier,
the current flowing through wet circuits can do long-term damage.
d. Drying
Your iPhone: It is a myth that you can dry your wet iPhone by placing it a
bowl of rice. Here is step by step guidance on of to dry off a wet iPhone.
1. Dry off exterior: To
kick off iPhones exterior gently shake off the water out of any holes, ports,
and sockets. Perhaps, you use protective care – remove the case and shake
again. Also, you can wipe out the exterior of the iPhone with a clean and dry cloth.
2. Dry
off interiors: Once you have cleaned the surface of an iPhone next its turn
to clean the interiors. Remove the battery section of the phone, remove Sim
card and memory card, then using a dry clean cloth wipe off the water (if any).
e. Turn
On Your iPhone: Now, you can wait for a few hours, before switching your
phone back.
Follow the
aforementioned step to get back you iPhone X in working condition after water
damage. In case your iPhone is not working then perhaps it’s a motherboard
issue. iPhone Motherboard repair in
Singapore can help you to get your iPhone motherboard back in functioning
state. Make sure to check with experts and gain information on the complete
process before choosing to go for a service.
Comments