Service metal briquetting machine

by allen guo Food Processing Machinery

In general, the briquetting machine can be guaranteed After normal use, the fault is greatly reduced and the service life will be extended for several years:

Recommended Features

1. Clean the inside of the briquetting machine once a week to remove stolen goods and ensure cleanliness;
2. Lubricate the surface of the cam and the place where the briquetting machine connects the shaft every week;
3. The upper skateboard and middle knife need to be cleaned every month, and lubricating oil needs to be added once;
4. Every other year, the oil in the reduction gear box needs to be replenished;
5. It is necessary to pay attention to several parts that cannot be lubricated: send and retreat with rollers, all belts, slip sheets and surroundings, electromagnetic clutch;

Learn more about Service metal briquetting machine»

Review on Service metal briquetting machine

In steel mills, we can often see the use of metal briquetting machines. Metal briquetting machines can improve the recycling rate of scrap steel and are widely used in the non-ferrous metal smelting industry. Using a metal briquetting machine can press various metals into different shapes. In order to extend the service life of the briquetting machine and also to ensure daily normal use, the following points need to be done. In general, the briquetting machine can be guaranteed After normal use, the fault is greatly reduced and the service life will be extended for several years:

1. Clean the inside of the briquetting machine once a week to remove stolen goods and ensure cleanliness;

2. Lubricate the surface of the cam and the place where the briquetting machine connects the shaft every week;

3. The upper skateboard and middle knife need to be cleaned every month, and lubricating oil needs to be added once;

4. Every other year, the oil in the reduction gear box needs to be replenished;

5. It is necessary to pay attention to several parts that cannot be lubricated: send and retreat with rollers, all belts, slip sheets and surroundings, electromagnetic clutch;

6. Each time the briquetting machine refuels, there is no need to add too much to avoid failure of the micro switch due to oil immersion.

During the briquetting process of the metal briquetting machine, the inner hole of the briquetting barrel often needs to be lubricated with graphite, asphalt, glass powder, etc., plus some metal residues, especially when copper and steel briquetting, there are often some metal oxidation due to heating Therefore, the briquette barrel must be cleaned at any time. According to the specific situation, each briquetting cycle can be cleaned once, or several briquetting cycles can be cleaned once. In short, the bridging cylinder must be cleaned. Most of the cleaning of the briquette barrel is performed manually, or with a cleaning gasket, which can bas