What Commonly Causes Burnouts In The Hot Water System Elements?

The electric hot water systems are extremely essential to keep the hot water flowing for every household size. For keeping up to their intact functionalities, primarily the heaters rely on upper and lower metal heating element pairs. Right with the passage of heating elements through them, the heating elements become much hot, which in turn helps in water temperature regulation. For accurate and proper control, a separate thermostat operates the heating elements.

The concentrated heat amount in square inches is said to be watt density. The elements belonging to the same wattage input could be either longer or shorter compared to their counterparts due to t medium, low, or high watt density. Usually, the elements of particular lengths are used for fitting within the defined diameter of the water heater tank's constraints. Low watt density elements have a typical capability of lasting longer compared to the higher watt density elements as the heat gets spread over the greater surface area.

Whatever might be the case, you have to call the hot water repair professionals in the cases of eventual burnout because of the following reasons –

i. Sediment Accumulation and Build-Up

Since the water condition from your plumbing systems is sure to vary based on your location, so a lot of it will contain the sediments coating the hearting elements. Just as the coating becomes severe, gradually the heating elements will stop its heat transferring procedure to the water and undergo burn out. Such a condition will be common to the bottom elements as the particulate matter precipitating from the heater water will start gathering and accumulating on the bottom of the tank. As the water conditions harden, the chemical reactions will take place faster with the heating elements.

ii. Occurrences of Dry Fire

Dry heating is the most common cause of heating elements burning out. Dry fire takes place when the hot tap of the newly installed water heater is not opened while water is filling the water heater tank. Subsequently, it will cause bleeding air from the hot water system. As this situation takes place and goes on, the air pocket has the possibility of developing in the tank's top position that will expose the upper heating element to the air. Whenever the heating element will be burned in an air pocket, then it will start generating excessive heat enough to melt the copper and eventually result in causing serious damages to the heater.

iii. Disruptions in Electric

As the heating elements are based on electricity, so they are subjected to certain changes likely to occur on the power source. While a few electrical problems have the possibility of directly affecting your heating elements that include a high voltage presence and power surge that the electric utility company generates.

When lighting will strike the power lines, then it will result in spikes in the electrical system. This problem has a frequent solution, which is energizing the heating elements at much lower voltages.

The heating elements are much critical when they have to make your water supply hot as per the temperatures you are preferring. But make sure you solve the burnout issues occurring on your hearting elements by hiring the hot water repairing specialists. Being professionals, they are offering a complete range of services for water heaters, which comprise installations as well as general servicing.