Star C3 Multiplexer COM port Configuration in Das xentry
Mercedes-Benz Star C3 Multiplexer use COM port com communication, when you run the DAS xentry software,
you have to set the right Com port, and in order to avoid "Error during
initializing, no link could be established between the diagnosis
gateway and the control unit" error message when using the Star C3
Multiplexer. this guide will guide you How to configure Star C3 COM port
in Das xentry
1) Right click "My computer" and click "Properties”
2) Click “Hardware”>> “Device Manager”
3) Find out “Ports(COM&LPT)”>> “PCI-COM(COM 2)” >>Properties
4) Select “Port Settings” and check the value as picture below
5) Confirm settings and click “Advanced”
6) Tick “Use FIFO buffers” and select COM Port Number as “COM2”. Click “OK” to save setting.
NOTE:
1)
If you get this error: "Com port Assigned Close other use "(COM2 is
well set) when launch HHTWin when running MB Star C3 DAS on VMware win 7
laptop
OR
2)
When you do a rapid test with DAS after to select ESP or SRS for
example, hht windows open with this message: "com port busy, close other
application"
Solution:
Close
other program that would interfer Mercedes-Benz Star C3 Multiplexer. If the application
does not close properly HHTwin open. Com port will remain open
continuously. Click Start >> all programs>> Star
Diagnosis>> HHTWin Stop.
Comments