Spinel crusher for sale in South Africa

　　Crusher referred back-breaking, is the development of new mid-nineties, the stone crushing equipment, is the world's widely used to replace cone crusher, roller machine, ball mill models. Stator and rotor are insulated from each other by a quartet built silicon, it is part of the magnetic circuit of the motor. Stator and rotor core damage and deformation caused mainly by the following aspects reasons

Spinel crusher for sale in South Africa

　 　  1, bearing excessive wear or bad assembly, resulting in the stator and rotor phase rub the iron core surface damage, which causes a short circuit between the silicon, iron loss increases the motor, the motor temperature is too high. Then use a fine file to remove burrs and other tools to eliminate silicon steel short, coated with insulating paint to clean up after, and heating and drying.

　　  2, removal of the old winding when the force is too large, so the Pirates slot skew and flared. In this case the application needle nose pliers, wooden hammer and other tools to be trimmed, the teeth bad reset and there is a gap between a bad reset of silicon joined Shell Green Paper, plastic wood and other hard insulating material.

　　  3, due to damp and other causes core surface rust. At this point we need to use sandpaper to clean, clean up after coated with insulating paint.

　　  4, around the group ground to produce high fever burned core bad tooth or section. Available chisel or scraper tools such Deposition was removed clean, coated with insulating paint drying.

　　  5, between the core and the base binding loose, you can tighten the original screws. If the screw failure in heavy machine base positioning holes drilled and tapped, tighten the screw.