Solutions for Oil Or Gas Leakage in Diesel Generator Sets
by Starlight Generator dieselgeneratortechDo you know what solutions are there for oil leakage, water leakage or
air leakage in diesel generator sets? When diesel generator sets have
oil leakage, water leakage or air leakage, it will cause diesel
generators to increase fuel consumption, accelerate component wear, and
reduce power, etc. Fault. Therefore, it must be repaired in time. The
following is the treatment method when the diesel generator set
has oil leakage, water leakage, and air leakage. First, the size
recovery glue is used to cure the leakage. The shaft and sleeve, bearing
and bearing seat, valve and valve seat, self-tightening oil seal, When
the felt cups and packing fillers leak, the size recovery glue can be
applied to the cleaned and worn parts of the mating parts. After curing,
a wear-resistant, heat-resistant, and mechanically strong film layer is
formed. Carry out machining, such as turning, boring, scraping, filing,
etc., to restore the geometric shape and matching accuracy of the
parts, so as to solve the leakage problem.
Leakage control of paint chip liquid, leakage at the joints of diesel
fuel tank, water tank, crankcase, etc., after soaking the paint chip in
alcohol, apply the paint chip liquid to the cleaned joints to cure the
leakage. However, the cost of lacquer chips is high, and they are
generally used in emergencies. Leakage control method with viscose glue,
when the body parts of the diesel engine, such as blisters and pores in
the fuel tank, water tank, oil pipe, water pipe, etc., cause leakage,
apply viscose glue to the cleaned damaged area, and then the leakage can
be cured. Effect. With the oil leakage control method, when the paper
pads of diesel engine oil pan, cylinder head, gear cover, crankcase rear
cover, etc. leak, as long as the paper pad is intact and the joint
surface is clean, you can apply a piece of paper on both sides of the
paper pad. Use a layer of butter and tighten the bolts to prevent
leakage. If you change to a new paper pad, soak the new paper pad in
diesel for 10 minutes before installation, then take it out and wipe it,
and put a layer of butter on the joint surface before installing it.
Anaerobic glue is used to control leakage. When there is leakage in the
vent bolts, stud bolts, plugs, etc. on the diesel generator set, apply
anaerobic glue to the cleaned bolts, threads or screw holes, which can
quickly solidify and form The film fills the gaps of the parts and can
withstand greater pressure. At the same time, it also has the fastening
function of strong shock resistance and anti-looseness. If it is used at
the thread of the diesel engine high pressure oil pipe joint, the
leakage control effect will be better. Liquid sealant leak control
method, when solid gasket defects appear on diesel generator sets to
form interfacial leakage and destructive leakage, apply liquid sealant
on the cleaned solid gasket joint surface, which can form uniform and
stable after solidification , The peelable film gasket with continuous
adhesion can prevent all leakage. Padded leak control method, oil
leakage at the leak-proof gasket of diesel oil pipe joints, a layer of
double-sided smooth thin plastic gaskets can be added on both sides of
the leak-proof gasket, and the leak can be prevented by tightening it
forcefully.
Starlight Power was founded in 1974 and is one of the earliest manufacturers of generators
and diesel generator sets in China. If you want get more information,
please feel free to send email to sales@dieselgeneratortech.com we will
pay highly attention on your question.
Sponsor Ads
Created on Jun 15th 2022 04:38. Viewed 162 times.
Comments
No comment, be the first to comment.