Software and user manual for Hitag-2 V3.1 key programmer

Hitag-2 key tool is new car key programming tool, you can program, generate key, Clone transponders by Hitag-2 Key Tool, here, we share the user manual for Hitag-2 key programmer

just give some demonstration about Read eeprom dump from CAS2

1. If you use Transponder you must switch Operation mode in PASSWORD.If you use key you must switch Operation mode in Crypto.
2. Push button - Load immobilized dump and choose readed eeprom from CAS2.
3. Next step is to write what number of key you want to programm in CAS2 ( in this example is Key number 3) after push
button Generate key and Hitag2 key programmer will clone Transponder (or Key).
4. After finishing programming you see message: Programming done.
5. After successcull programming of transponder or key you must push button - Save immobilizer dump
6. Write new name of modify by software dump.
7. Save this new dump and programm in CAS2. Now you can start car with this transponder

Hitag-2 V3.1 software free download:

http://pan.baidu.com/s/1kTJsgPh