Renault Megane III Key Programming with Autel IM608
by Alex Carter Mechanic Assistant How-to: add a spare keyless-go remote key card to Renault Megane III year 2009 to 2015 by using Autel MaxiIM IM608 key programmer. No doubt the smartest investment for your workshop.Tools needed:
IM608 tablet
2 key cards, original key card and blank key card
Enable network connection (required when reading password)
Original key can start engine
New blank key cannot start engine
Procedure:
Insert original key card into card slot and turn on ignition switch
In Autel IM608, Select IMMO function->Manual selection->Renault->Megane III->2009-2015-> Keyless System (CAN)->Key learning->Learn the key
Both 2 keys need to be learnt
Remove key card from slot and turn off ignition
Push START/STOP button to wake up car activity if in sleep mode.
Press OK to start key programming
Reading password in progress
Make sure network is enabled
Note:
1.No data is programmed to card in next step
2. Max 2 blank card can be presented for programming (4 cards in total)
3.Blank card that was not presented during next step, will not be accepted during learning step.
Insert next key card and press READ button to read card information
Press Next to continue
Remove card
Insert card (original key card) fully to the card reader slot and then press OK
Programming card in process
Program key card success. Press Yes to program next key card
Remove 1st key card and insert 2nd one
Follow same steps to program 2nd key card until success
Remove card and disconnect Autel MaxiIM IM608 key programmer
Test remote control and start engine with the new key card.
Both key works.
www.obdii365.com
http://www.key-programmer.org/2019/05/05/program-renault-megane-iii-09-15-key-card-with-autel-maxiim-im608/
Sponsor Ads
Created on May 5th 2019 00:43. Viewed 516 times.
Comments
No comment, be the first to comment.