I Phone disassembly and repairing procedure

by John La consultant

Opening the case will void the manufacturers warranty if any leftovers. Top Techies is not responsible for damage or problems that may result from following the disassembly and replacement events. Please observe all static safe precautions while working inside your iPhone mobile or IPhone parts. These instructions require a high level of technical ability and proficiency in the use of hand tools as well as a general understanding of electronic mechanisms. Buyer assumes full responsibility for the installation of this replacement battery.

Preparation:

 Start with a clean, open table that has good flow. Ensure the location you selected has access to a wall outlet for the soldering flatten. Make a note if you've had issues with static electricity in the atmosphere. If yes, you may want to use a static wrist band or ground yourself prior to starting disassembly.

Tool Reality Check:

You will need additional tools to open the container. IPhone parts case tolerances are extremely tight making the case removal tricky. The plastic opening tool is mainly used to release connectors and leverage the battery from the box. You will need a small flat head screw driver to leverage the iPhone case unlock. We'll show you a few case opening techniques in these instructions.

Battery Replacement Approach Options mobile phone parts:

Topics uses the battery splice technique for all of our pro mechanisms. The reason being the battery connectors (metal connector tabs) on the system boards are very fragile. They are so sensitive that Apple has glue covering the connectors to help prevent them from pulling up and doing. If you have a connector that pulls up during the battery replacement process you will need a new system board.

The wire splice technique involves clipping the old battery wires up near the battery to keep the maximum length and then splicing in the new series. We use a wire heat shrink wrap to cover and protect the joint. You would need the smallest heat shrink wrap you can find and it can be purchased at Radio shed. The technique we explain in this document is the slightly more risky option of unsoldering the connections on the system plank. You'll need to make a decision on the technique you want to use. Of course, it’s never too late to have Top Techies replace the battery for you.

Required Tools are here such as  soldering level, flat head twist driver, case opening instrument, & small paper clip.

 Power Off iPhone & Remove SIM Card

Hold down the power button for 5 seconds and shut down. Remove the SIM card and The holder uses a small paper clip or join. If the SIM card holder is not removed you will damage the iPhone upon case removal.

 Remove Back Plastic Panel

Using the case opening tool or small flat head screw driver leverage it into the edge where the plastic meet's the aluminum support. It's usually best to start near the side or edge of the iPhone mobile. The black plastic piece should pop-off after enough pressure is functional. Set this piece aside in a safe area.

First you should go through the above steps and the information regarding next steps we will tell in the next part of the our article.

 

Minidigital IT is an independent provider of PC/Network advice, maintenance and support Professional IT service provider,  We service all brands Our professional Microsoft certified mobile phone parts technicians provide on-site  iPhone parts   services and upgrades in the Perth metropolitan area For more information visit now http://it.minidigital.com.au/

Sponsor Ads

• Ad Space Available - Rent it Now!

Created on Dec 31st 1969 18:00. Viewed 0 times.

Comments