Articles
How to Use Honda HDS Program New Key for Honda Odyssey 2008
by Dave Jack Auto Car Repair Knowledge When the Honda ECM/PCM is replaced, it is necessary to be recognized a code each other to the ECM/PCM and the Immobilizer Control Unit-Receiver with the HDS. Also, the vehicle with Keyless Access System needs to be recognized a code each other to the ECM/PCM and Keyless Access Control Unit. Otherwise, the engine cannot be started.Preparations:
How to Install Honda HDS Software for DIY
Newest Honda HDS V104 V102 Free Download
Honda HDS 3.104.002+I-HDS+ECU Rewrite+Immobilizer Tool
Procedures:
System Selection Menu, click [IMMOBI]
Note:Not all systems may be available on this vehicle.Refer to the Service Manual for further information.
Click [Replace ECM/PCM]
IMPORTANT:
For vehicles equipped with Keyless Access System,use the actual immobilizer key in the remote to register and diagnose the system.
Press tick to continue
Obtain PCM-code from MaRIS2/GENPO/Distributor
Input PCM-code and Press tick to continue
Turn the ignition switch off
Turn the ignition switch on
Turn the ignition switch off. The registration of immobilizer codes into the Immobilizer unit has been completed.
Press tick to continue Check all keys to ensure each will start the engine
Is this vehicle equipped with a KEYLESS ACCESS Remote System?
Click [NO]
The registration is complete.Press tick to continue
Done!
https://www.autoepccatalog.com/product/honda-hds-diagnostic-software-i-hds-ecu-rewrite-immobilizer-tool/
Sponsor Ads
About Dave Jack 
Auto Car Repair Knowledge
18 connections, 3 recommendations, 173 honor points.Joined APSense since, April 13th, 2017, From Tukwila, United States.
Created on Aug 11th 2020 20:01. Viewed 317 times.
Comments
No comment, be the first to comment.
