How to Use CG100 Prog Repair Honda Airbag
by Launch Creader Auto Workshop How to use CG100 PROG III to repair airbag on Honda ECU 77960-T9A-F411-M2 R5F2154 in step-by-step procedure.CGDI BMW ProgrammerModel: Honda
No.: 77960-T9A-F411-M2
Chip: R5F2154
1.Power off the vehicle, remove the airbag computer, check the style and the chip.
2.Open the CG100 special software, choose "Airbag", then "Honda", and wire according to the wiring diagram.
3.After confirming that the wiring is correct, CG100 PROG III is powered on, operate it according to the software prompts in step by step procedure.
Note: Please do not touch any cable when it is reading.
Save file successfully.
Note: Please do not touch any cables when it is repairing.
4.Get message "Repair successfully", please put the airbag computer back on the car and test it if it is ok.
CG100 III tech support is offered by www.obd360.com
Sponsor Ads
Created on Jun 13th 2019 20:25. Viewed 672 times.
Comments
No comment, be the first to comment.