How to setup your DigiProg III odometer correction

Some customers feedback the DigiProg III odometer correction not work, one reason is they failed to setup it. Here OBD2Repair would like to share with you how to setup your DigiProg III odometer correction

 

Digiprog 3 is obd2repair 2012 latest version odometer correction tool. Digiprog 3 odometer correction now is v4.82 version. Digiprog III tachopro odometer tool support Alfa, Aston Martin, Audi, Bentley, BMW, Cagiva Raptor, Chevrolet, Chrysler, Citreon, Daimler Benz, Dodge, Ferrari, Fiat, Ford, GM, Honda, Hyundai, Jaguar, Kia etc.

Here are the instrcutions of setup Digiprog 3

 

1. A regulated 12 volt power supply should be used to power your DigiProg III. If anything above 13.5 volts is used to power the machine, damage may be caused to the main circuit board and it will need to be sent to your DigiProg III dealer for repair.

2. When connected to a vehicle by OBD DO NOT use the cigar lighter lead, the Digi takes power from the vehicle. Failure to observe will result in damage not covered by the warranty.

3. When your DigiProg 3 is powered up, this screen will be displayed whilst your machine is loading:

4. On this screen your DigiProg’s status/software version is displayed along with your machines unique 12 digit electronic serial number.

5. When your DigiProg III has finished loading an information screen will appear with a disclaimer regarding the use of the machine.

6. When you are ready, press the check/tick button.

7. The DigiProg will then ask for a password to be entered before the machine can be used. The default password is set to "1"

8. Then your DigiProg 3 is ready to use.

More information, pls visit Digiprog 3 odometer correction digiprog III Mileage correction