How to Repalce Cooling System Water Temperature Regulator for Caterpillar C11 Engine
by Dave Jack Auto Car Repair KnowledgeThis instruction show you guide on how to Repalce Cooling System Water temperature Regulator for Caterpillar C11 Engine.
Caterpillar SIS 2020 2019 Full EPC+Service Manual Free Download
Replace the water temperature regulator before the water temperature regulator fails. This is a recommended preventive maintenance practice.
Replacing the Caterpillar water temperature regulator reduces the chances for unscheduled downtime.
A water temperature regulator that fails in a partially opened position can cause overheating or overcooling of the engine.
A
water temperature regulator that fails in the closed position can cause
excessive overheating. Excessive overheating could result in cracking
of the cylinder head or piston seizure problems.
A water
temperature regulator that fails in the open position will cause the
engine operating temperature to be too low during partial load
operation. Low engine operating temperatures during partial loads could
cause an excessive carbon buildup inside the cylinders. This excessive
carbon buildup could result in an accelerated wear of the piston rings
and wear of the cylinder liner
CAT ET 2020C & 2019C Full Service Download
Failure to replace your Caterpillar water temperature regulator on a regularly scheduled basis could cause severe engine damage.
Caterpillar
engines incorporate a shunt design cooling system and require operating
the engine with a water temperature regulator installed.
If the
water temperature regulator is installed incorrectly, the engine may
overheat, causing cylinder head damage. Ensure that the new water
temperature regulator is installed in the original position. Ensure that
the water temperature regulator vent hole is open.
Do not use liquid gasket material on the gasket or cylinder head surface.
Refer
to the Service Manual for the replacement procedure of the water
temperature regulator, or consult your Caterpillar dealer.
Note:
If only the water temperature regulators are replaced, drain the
coolant from the cooling system to a level that is below the water
temperature regulator housing.
CAT SIS Caterpillar SIS EPC Software Download
Sponsor Ads
Created on Apr 19th 2021 20:20. Viewed 219 times.