How to Lay Tile Using Secure Technology Paving on the Wooden Floor
by Sumit Jain Content WriterTiles on wooden floor mounted than traditional concrete solution
which is rapidly degraded in wood, and using modern technologies. Many
people mistakenly believe that the ceramic and wooden planks - incompatible
materials. Truth
in such opinions is, and until recently this arrangement was considered
ineffective. Today,
when there are new lining materials and specially developed adhesives task is
feasible.
In fact, the wooden floor - a "cake" made of several
layers:
·
Wooden logs
·
Board subfloors
·
Substrate (DSP, plywood, chipboard, etc.)
Before starting work, carefully inspect the current operational
status of all layers of the "pie." If some of them fell into disrepair, should dismantle the old
stuff. Necessary to form a solid level
base. Ceramic tile has a certain
weight, especially in combination with adhesives and leveling materials. It is important that the old wooden base withstood this load is
not deformed, not bent, not cracked. Prepared
according to the rules provide an effective basis for laying tile, durable and
last for years.
Preparing
for Wooden Flooring Tiling
First, you must clear all the decorative coatings. This can be done in three ways:
·
Mechanical action
·
Chemical treatment
·
Temperature heating
Old
floors can have on the surface of many layers of old paint, which is very
difficult to remove from the timber. Try to spread on an electric drill emery wheel with abrasive
number 40 and walk on the surface. If mechanical treatment does
not give good results, apply the treatment of old paint solvents. The combination of high-temperature dryer and scraper can also
give a good cleaning result. And most importantly - the
speed of the process. It all depends on what floors
were covered with every repair.
When
wood floorboards cleaned, you need to take a grinder or abrasive paper for
finish grinding. Grains in this case should be
fine. Floors are cleaned in 3 doses - along, across
and diagonally.
Now
prepare subfloor. To do this we need to install
wooden logs, put a waterproofing material, lay plywood (or particle board). This is to tile on a wooden
flooring is flat. Lags exhibited strictly using
building level. Subfloor must retreat around
the perimeter walls at 10 mm.
Prepare a wood floor under the tile is held in the following
order:
·
Processing joints. The joints between the wall and
the sub-floor filled with foam for waterproofing.
·
Antiseptic protection. Timber is applied with a brush
or a special protective impregnation linseed oil.
·
Application of latex. With a broad brush applied to
the surface layer of thick latex.
·
Installing a paint grid. Immediately after applying the
latex paint is laid on the surface of the grid, and left there to dry.
·
Fixation. After drying mesh fastened with
screws to the plywood or particleboard with a frequency sufficient to fit the
desired density.
·
Processing insulating mixture. The surface is covered with plywood or
chipboard with a mixture consisting of 2 volume waterglass, 2 parts sand to 1 part
water.
Prepared
wooden base must be leveled leveling instrument. After that, if there are no
differences, you can begin to cover the floor and cooked selected tiles. Conditionally divide the
process into 4 stages. We need to turn:
·
Mark the floor
·
Prepare adhesive means
·
Lay Floor
·
Wipe the joints between the
tiles
From
the middle of the short wall of the room draw a line through the middle of the
cord to chalking the wall opposite. Do the same basting from the center of the
long wall to the opposite. In the center formed a crossroads, the intersection point. You can start the installation of tiles from her. Especially
convenient to do it, if you chose a diagonal arrangement. In this case, you will have a lot of cutting elements. Beginning work on the center of the room, you can put the entire
visible seamless tile floor space, and only the walls put cutting fragments.
Now
prepare the substance which we will stick tile or porcelain tile on the floor. The stores sold a lot of dry
mixes for the preparation of cement glue. Buy the right amount; mix with
water according to the instructions. To enhance the adhesion of the
solution and add tile plasticizer mixture (approximately equal to 15% by weight
of the adhesive).
From
mixer woo uniform consistency substance. For once cook a small amount as 3-4 hours cooked dry volume. Apply
mass need a notched trowel on a wooden base, treated soil. The surface must be dry. Tile large spatula, take the
large size of the teeth. Glue is applied at an angle
extending from the central point, straight strips. Approximate lot size for a single application of - 1 m. m
Before
putting tiles on wooden floor,
prepare it. You can gently brush to moisten
the underside. Cutting position on the
prepared fragments must be well sanded. Check if there are defects on
the face. Stacking alternately prepared piece goods,
gently tapped each tile a small rubber mallet. Take the time to
check the location on the horizontal surface of each of the tiles. If noticed a drop in the level, add a little glue under the tile. Work carefully, but do not hesitate. Adhesive compound dries quickly, and to remedy defects, correction
of errors you have very little time.
To cover looked aesthetically pleasing, during
installation, use the plastic crosses. Remove
them immediately after installation of two or three adjacent tiles. Received stitches after installation
of the coating should overwrite (fill in the fugues). First with a brush all the gaps
requires moisten, then apply diagonal movements special grout trowel. Remove
excess. Wait half an hour to dry
joints and wipe with a damp cloth its new floor covering. The distance between the tiles can be
from 2 to 6 mm. For seamless
coverage, you can buy a special tile, stacked end to end.
About Author: The article is written by Sumit
Sain via www.eurotexflooring.com, he is a
well experienced person in wooden flooring for homes, offices and apartments in
India. From last many years he is in the same field with Eurotex Flooring which
covers all solutions like wood flooring like Solid, Laminated and Engineered
and wall decking & cladding.
Sponsor Ads
Created on Dec 31st 1969 18:00. Viewed 0 times.