How to Fix HP LaserJet Printer Fuser Error 50.2
How to Fix HP LaserJet Printer Fuser Error 50.2
HP Laser Printer may suffer from one of the common errors
named as Fuser Error 50.2. In this blog, you will find many reasons that will
be responsible for this issue to take place and various resolution methods
combined with the set-up of HP laser printer. It will be so painful if your
printer gets stopped suddenly while taking some important pages print. But,
there is also one other method to fix it, i.e., calling HP Printer Contact Number.
How To Reset HP Laser Printer For Removing Fuser Error 50.2?
Method -1 Turn OFF & ON Once
Printer Gets Heat-Up and Clean It
This error
normally occurs because of heat generated inside the HP Laserjet Printer.
First, turn on the power switch and second, turn it off. If the printer
restarts, its temperature level will be normal, and it will not have any heat
build-up issue inside it.
One way to
recover this error due to heat generation inside the printer is just to switch
off and switch on the power mode button. Once you switch off the printer, check
the damage happening inside it because of heat build-up issues. If any extra
paper is stuck to it or clogged ink, it is recommended to remove both without
delay. This way, you will eliminate fuser error 50.2 and prepare the printer to
run efficiently.
Read also: Hp printer is not working
Method - 2 Make Sure Power Source is OK
The heat
generation problem may arise at your power source. It is recommended that while
operating your printer, keep an eye on the power source too to avoid fuser
error 50.2 unnecessarily.
The plugs
inserted in the power source should be similar to machine plugs to transmit
high volume of electricity supply to the printer. The broken or loose power
cable may be responsible for the heat-up issue and this way fuser 50.2 error.
Make sure that a good quality power cable is used in a printer to take the
power supply from the power source.
Method – 3 Measure the Temperature
of Printer’s Location
Make sure
that the printer should never be located in an extremely cool environment. You
must ensure that if the printer location is changed, it should be given time to
adjust with the changed location environment. It means the printer should be
given time to warm-up according to the location environment.
Method – 4 Replace Fuser With A New
One
Check the
impact of the fuse in your printer, take out the fuser assembly, make sure that
everything is running smoothly, and reset it. If all above actions are unable
to fix your printer's error, then replace the fuse with a new one.
The
above-recommended methods can troubleshoot hp
laserjet fuser error 50.2 in your HP laser printer. If these steps are
found difficult for you, it is the best way to connect with HP Printer Contact Number. You will get
the instant solutions to eradicate this fuser error by connecting with
technical specialists. The helpdesk service is available 24/7 hours to assist
you in troubleshooting complex level issues.
Comments