How To Fix An HP Printer That Won't Turn On?

by Printer Support Usa Get Instant Printer Support Service

A series of printers from HP is reliable and high-performing. However, the printer may occasionally have a number of issues. There are several complaints that HP printers won't turn on. They are in the middle of printing when the printer abruptly cuts off. After that, the device simply won't switch on, no matter how hard they try. Hardware issues are often the root of this problem. The user must be aware of how to resolve this issue when it arises.

Fixes To Use When HP Printer Does Not Turn On

1. Test The Power Source With A Different Power Cord.

· Check to see that your power source is operating properly. If you have a separate power cord, connect it to the outlet and the printer.

· Plug the cord out of the wall outlet or power strip.

· Connect a different functional outlet to the printing device.

· Activate the printer. You can stop here if it starts to operate. But if not, proceed to the next action.

· Look for a cord with the same type of connection as the one on the printing unit. Connect the cord now to the printer and the wall outlet.

· Activate the printer. I'm hoping it will turn on.

2. Perform a Manual Reset to Restore the Printer’s Power after a Power Outage

· Start by unplugging your HP printer's power supply.

· After that, remove the ink cartridges.

· Wait for a minute or 60 seconds.

· Reconnect the printer's power cord after that.

· Turn on your printer at this time. There may still be no electricity to your printer. If you observe this, take the following actions.

· Replace the ink cartridges for the printer. Close any doors or lids that are currently open.

· If the printer hasn't already started, try turning it on again.

3. Disconnect The USB Connector

If the above methods don't work out for you, try this one. The HP printer's USB port is located at the back. Once it's disconnected, turn on your printer. If the printer starts up flawlessly, the USB cord is likely to be the cause of the issue. So, the right option is to remove or replace it.

4. Set Your HP Printer As The Default

5. Turn The Printer On

Hope you find this article helpful; even you are facing an issue with your hp printer, reach customer service at helpline no. +1 866-918-4391 or visit our official website https://printsupportusa.com/