High pressure grinding will replace Raymond grinding powder industry leader

With the development of society, requirements of enterprises on powder mill is also more and more high, the fineness of product is low, the General Raymond grinding fineness is generally below 500 meshes, these devices can only occupy the powder application market lower, but the high failure rate of machinery, power consumption, noise, pollution. The old Raymond mill the low efficiency of the system, collection system separation effect of the product is not ideal, a fine powder is not effectively collecting and recycling within the system caused by the power waste. Then the development of 3 to 5 years of new mill equipment -- high pressure grinding is likely to completely replace the Raymond Millbecome a leader in powder industry in.

New type high pressure grinding is based on long-term experience in R & D of powder, in accordance with the requirements of domestic and foreign several mill user and suggestions, the new milling equipment on the basis of the original Raymond mill through painstaking research design, thus creating a new era of international industrial grinding efficiency, low energy consumption.

Compared with Raymond mill grinding in high pressure under the same power conditions, yield increase of 10-20%, the grinding pressure roller on material to improve 800-1200kg in the high pressure under the action of the spring.

High pressure roller mill grinding device adopts chongdieshi multistage sealing, good sealing performance. The product size range, the coarse particle size up to 0.613 mm (30 mesh), diameter up to 0.033 mm (425 mesh), a small part of the fine material can reach 0.013 mm (1000 mesh). The dedusting effect it completely meet the national dust emission standard.

Sponsor Ads

• Ad Space Available - Rent it Now!

Report this Page

Created on Dec 31st 1969 18:00. Viewed 0 times.

Share on APSense

Comments